Rev -
I-00307
NOTE: You will need to have Service Tracks (Part# TRACK50) and Service Stand (Part# TRACKL)
readily available in order to complete these instructions
1) Remove Enclosure from skid.
2) Use a knife to remove the stretch wrap that goes around the front Squaring Panel.
CUT HERE
(ALWAYS CUT AWAY
FROM YOURSELF)
3) Using the supplied Allen Key, remove the four Wood Shipping Braces (8 Screws).
4) Remove the four #2 Phillips Head Screws holding the Locking Trim Panel on the bottom
of the enclosure. Set the locking trim panel aside for future use refer to provided instructions.
5) Install Service Stand and Service Tracks. Refer to the instructions (I-1002) provided with the
Service Stand/Tracks.
NOTE:
Rack will not pull out until the next few steps are completed.
REMOVE SCREWS
(4 PLACES)
ALLEN KEY
SHIPPING BRACE
SCREWS
TOOLS / PARTS REQUIRED
- #2 Phillips Head Driver - Service Tracks (Part # TRACK50)
- 7/16" Wrench
- Service Stand (Part # TRACKL)
- Knife - 5/32" Allen Key (Provided in the
- Wire Cutters instructions stretch-wrapped to the
squaring panel)
MRK-XXXXAXS UNPACKING INSTRUCTIONS
REMOVE CAPS BEFORE
INSTALLING TRACKS
(2 PLACES)
Page 2
INSTRUCTIONS CONTINUED
6) Remove the two #2 Phillips Head Screws from the AXS Securing Bracket in rear of rack (2 Places).
7) Cut the Wire-Ties holding the two Cable Carriers in place.
8) Loosen 7/16" bolt holding AXS Securing Bracket in place. Slide Bracket forward and remove.
NOTE:
Slide out rack for better access to Securing Bracket.
CABLE CARRIER
WIRE TIE
AXS SECURING
BRACKET
NOTE: TO ENSURE THE ENCLOSURE REMAINS SQUARE DO NOT REMOVE THE SQUARING
PANELS UNTIL SOME EQUIPMENT IS INSTALLED
/
