2. Livex Lighting
  3. 41127-91
41127-91

Livex Lighting 41127-91, 41147-91 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Livex Lighting 41127-91 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What should I do before installing the fixture?
    How do I attach the mounting plate to the Junction Box?
    How do I connect the electrical wires?
    What should I do after connecting the wires?
    How do I install the light bulb?
    How do I contact customer service for assistance?
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
41147 41127
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and
all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Take care not to lose any small parts necessary for installation.
3. Thread the two mounting screws about 1/4” into the pre-drilled holes
in the mounting plate spaced the same distance apart as the holes in
the lamp body.
4. Attach the mounting plate to the Junction Box with the two Junction
Box Screws as shown. The side of the mounting plate marked
"GND" must face out. The junction box is not included.
5. Raise the canopy(A) onto lamp holder of the lamp body(B), by turn it
clockwise until tight.
6. While holding the lamp body towards the ceiling, connect the
electrical wires as Shown in Fig.2, making sure that all wire nuts
are secured. You may have to wrap the connections with electrical
tape. If your outlet has a ground wire (green or bare copper),
connect the fixture ground wire to it. Otherwise connect fixture’s
ground wire directly to the Mounting strap with the green screw
provided. After wires are connected, tuck them carefully inside the
Junction Box.
7. Raise lamp onto the junction box, aligning screws on mounting
plate with mounting holes of lamp, lock it securely with the ball
nuts. Raise the end grapnel of the crystal(C), hooked the bottom
small ring of the plate.
8. Install the light bulb(not included) in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE SPECIFIED
WATTAGE!
Your installation is now complete. Return power to the junction
box and test the fixture.
JunctionBox
(Notincluded)
Mountingscrew
Green
Screw
(GND)
JunctionBox
(Screw)
A
Ballnut
B
C
JunctionBox
(Notincluded)
Mountingscrew
Green
Screw
(GND)
JunctionBox
(Screw)
A
B
C
41147 41127
Ballnut
WHITE
HOUSE
Black
WIRES
(
Hot
)
FIXTURE
WIRES
BLACK
WIRES
FIXTURE
Bare
FIXTURE
WIRES
(Ground)
HOUSE
(
Neutral
)
WIRES
White
Green or
WIRES
HOUSE
Copper(Ground)
GREEN
Thread
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at: 800-761-8056
Or visit us online at: WWW.LIVEXLIGHTING.COM
©COPYRIGHT ALL RIGHTS RESERVED.LIVEX LIGHTING,INC. DOC20180641147
FIG.2
FIG.1
/