Allied Brass RW-3/18-ABR Installation guide

18.00

457.20

MOUNTING

SCREW (2X)

PULL ASSY

Step 1:

Determine your desired location for installation and make a mark for the location.Make 2 marks where mounting screws will

be placed as shown below. Drill hole at each of the marks.

Drill holes for the desired location.

Pull Mounting

Step 2:

Placed Pull to the desired location and screw from behind.

SURFACE MOUNTED

RW-3-18

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.