Ryvyr V-WAVE-24DE Installation guide

Type
Installation guide
TM
TM
For customer support please visit www.xylem.biz or call 866 395 8112 weekdays 8:00 to 5:00 EST or fax 866 395 8113 any time
INSTALLATION INSTRUCTIONS
WAVE
VANITY
V-WAVE-24DK
SUGGESTED TOOLS AND MATERIALS
Philips Screwdriver Level Drill Tape Measure Safety Glasses
1 0 '
ROUGHING IN
24" [610.0mm]
34" [864mm]
16" [406.1mm]
30" [762mm]
21-1/2" [546.0mm]
4” [101.6mm]
3" [76.0mm]
8" [204.0mm]
THANK YOU FOR CHOOSING XYLEM
Please take a few minutes to review this manual before you start installation. If you encounter any
installation problems, please don’t hesitate to contact us. Before you begin, please observe all local
building codes. Unpack the new product and inspect for damage. The appearance of your vanity may
differ from the illustrations in this guide. This instructions still apply. Please ensure the finished wall is
straight and plumb and the floor is flat and perpendicular to the finished wall.
For customer support please visit www.xylem.biz or call 866 395 8112 weekdays 8:00 to 5:00 EST or fax 866 395 8113 any time
• Position the vanity against the finished wall. If necessary, turn the leg levelers to achieve level.
• Mark the supply and drain locations on the inside of the vanity back wall.
• Move the vanity away from the wall and cut the marked supply and drain locations from inside.
• Position the vanity against the wall, aligning the supply and drain locations with the cut holes.
• Install the countertop, sink, drain and faucet according to the manufacturers instructions.
INSTALLATION INSTRUCTIONS
• To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid extreme
changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning units. Avoid placing furniture
directly under windows.
• Dust the vanity frequently with a clean, soft, dry, lint-free cloth, as well as polish it on a regular basis. Clean the surface by rubbing in the
direction of the grain. Avoid using silicone cleaners and waxes.
• Clean up excess water and spills immediately. Use blotting rather than a wiping action. Water left over a long period of time will cause
white spots in the finish. Please note that some chemicals may damage the finish.
CARE AND CLEANING
Mark & cut supply hole
locations on wall
Position vanity
against wall
Install sink, faucet,
& countertop
according to
manufacturer’s
instructions
**NOTE: items shown
are Xylem recom-
mended components
and are not included.
  • Page 1 1
  • Page 2 2

Ryvyr V-WAVE-24DE Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI