TM
TM
For customer support please visit www.xylem.biz or call 866 395 8112 weekdays 8:00 to 5:00 EST or fax 866 395 8113 any time
INSTALLATION INSTRUCTIONS
BAMBU
BASE
V-BAMBU-BAS-6DB / 10DB
Rev 3/07
THANK YOU FOR CHOOSING XYLEM
Please take a few minutes to review this manual before you start installation. If you encounter any installation problems,
please don’t hesitate to contact us.
Before you begin, please observe all local building codes. Unpack the new product and inspect for damage.
The appearance of your vanity may differ from the illustrations in this guide. This instructions still apply.
Please ensure the finished wall is straight and plumb and the floor is flat and perpendicular to the finished wall.
SUGGESTED TOOLS AND MATERIALS
Philips Screwdriver Level Drill Tape Measure Safety Glasses
10'
INSTALLATIONS INSTRUCTIONS
CARE AND CLEANING
• To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid
extreme changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning
units. Avoid placing furniture directly under windows.
• Dust the vanity frequently with a clean, soft, dry, lint-free cloth, as well aspolish it on a regular basis. Clean the surface
by rubbing in the direction of the grain. Avoid using silicone cleaners and waxes.
• Clean up excess water and spills immediately. Use blotting rather than a wiping action. Water left over a long period of
time will cause white spots in the finish. Please note that some chemicals may damage the finish.
V-BAMBU-BAS-6DB V-BAMBU-BAS-10DB
• Using the hex wrench provided, attached the base of the vanity to the bottom of the vanity.
• Position the vanity against the finished wall. If necessary, turn the leg levelers to achieve level.
• Mark the supply and drain locations on the inside of the vanity back wall.
• Move the vanity away from the wall and cut the marked supply and drain locations from inside.
• Position the vanity against the wall, aligning the supply and drain locations with the cut holes.
• Install the countertop, sink, drain and faucet according to the manufacturer’s instructions.
For customer support please visit www.xylem.biz or call 866 395 8112 weekdays 8:00 to 5:00 EST or fax 866 395 8113 any time
Hex Wrench
Hex bolt
Washer
Nut
-
1
-
2
Ryvyr L-BAMBU-36-10DB Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Ryvyr V-WAVE-24DE Installation guide
-
-
-
-
-
Hembry Creek S-MALAGO-30BK Installation guide
-
-
-
Ryvyr M-KENT-24WW Installation guide
-
Other documents
-
Hembry Creek V-KA-36BN Installation guide
-
-
-
Hembry Creek M-WYNCOTE-36BN Installation guide
-
-
-
-
-
-