bObsweep NW604001SV User manual

Owner’s Manual

How to employ your intelligent oor cleaner

bObi Pet™

2015

Congratulations on purchasing your intelligent oor cleaner! bObi is now

at your service. To see bObi at her best, please read the Quick Start

Guide and this manual thoroughly.

If you ever have questions or concerns, feel free to contact our helpful

team at [email protected]. Welcome to the bObsweep family and

happy cleaning!

Contents at a Glance

Important Safety Instructions 4

Components 6

Get bObi ready to clean 11

Battery 12

Turning bObi ON/OFF 13

Working Modes 14

Charging Station 16

bObi blOck 20

Remote Control 23

Mop 27

Customizable Cleaning Schedule 29

Time 31

Schedule 33

Maintenance 35

Dustbin 36

Filter 37

Main Brushes 39

Side Brush 41

UV Light 42

Front Wheel 42

Sensors 43

Blindfold Stickers 43

Storage 44

Troubleshooting 45

Checkup Guide 50

Warranty and Support 57

General Information & FAQs 59

Important Safety Instructions

Basic safety precautions should always be observed, including the following:

To protect against electrical shock, do not immerse any part of bObi in water or

other liquids. bObi’s dustbin may be washed with water only after her vacuum motor

has been removed.

Turn bObi OFF when she is not in use and before conducting maintenance.

If bObi, her remote control, her blOck, or her charging station has been damaged,

do not operate them. Contact our customer care center.

If bObi is not working as she should or has been dropped, damaged, left outdoors,

or immersed in water, contact our customer care center.

Do not handle bObi, her remote control, her blOck, or her charging station with wet

hands. Use bObi and her accessories only on dry surfaces.

bObi is not intended for use by persons (including children) with reduced physical or

mental capabilities, or lack of experience and knowledge.

Do not mutilate or incinerate the battery, as it will explode at high temperatures.

Do not expose bObi, her remote control, her blOck, or charging station to tem-

peratures higher than 45° C (113° F) or to moisture or humidity. Do not use bObi

outdoors.

Do not let bObi pick up toxic materials (chlorine bleach, ammonia, drain cleaner,

etc.).

bObi is composed of electronic components that in rare or unintended cases can

cause hazards of heating, re, or other malfunctions. Furthermore, because bObi is

capable of and intended for autonomous movement and cleaning, its use poses the

risk of collision with property, pets, and persons, and unintended removal of articles,

such as small valuables, jewelry, or hair of persons or pets lying on the oor, among

other objects.

Do not let bObi pick up anything that is burning or smoking, such as cigarettes,

matches, or hot ashes.

Do not use bObi to pick up ammable or combustible liquids such as gasoline, nor

use her in areas where they may be present.

Do not use bObi in an enclosed space lled with vapors given o by oil-based paint,

paint thinner, moth-proong substances, ammable dust, or other explosive or toxic

vapors.

bObi’s remote, blOck and charging station are composed of electronic components

that in rare or unintended cases can cause hazards of heating, re, or other mal-

functions.

Leaks from battery cells can occur under extreme usage or temperature conditions.

If the liquid gets on skin, wash quickly with water. If the liquid gets into the eyes,

ush them immediately with clean water for a minimum of 10 minutes. Seek medical

attention immediately.

Do not dispose of your battery in re. Old batteries should be recycled safely (check

with your local recycler).

Do not look directly into the UV light.

Do not use bObi for other than intended usage.

bObi

Charging station

bObi blOck

Remote control

2 side brushes

1 installed; 1 spare

2 Main brushes

1 installed; 1 spare

Charging adaptor

Components

What comes in bObi Pet’s box?

Cleaning tool

Extra screws & Blindfold stickers

Mop extension

2 Micro-ber mopping cloths

Filter replacement

Owner’s Manual, Quick Start Guide

Warranty Card

Phillips head screwdriver, Syncing tool

Extra main brush holders

Anatomy

Top view

Charging inlet

ON/OFF switch

Head sensor

Go!

Juice

Wae

Charging bars

Cover

Touch sensors

Wall sensors

Bottom view

Floor sensors

Side brush

Front wheel

UV light

Battery

Wheels

Duster

Main brush

Filter

Dustbin

Charging station

Remote

blOck

Get bObi Ready for Cleaning

Battery

When bObi rst arrives, her battery is not installed. To install bObi’s battery, place

bObi on a at surface and set her power switch to OFF.

1

Using the provided

Phillips head

screwdriver, remove the

screws on the battery cover.

2

Remove the battery

cover. Connect

bObi’s battery to the

circuit junction.

3

Tuck the wire into the

side of the battery

compartment and

slide the battery into bObi.

Turning bObi ON/OFF

bObi’s power switch is located on her side. Use this switch to turn bObi ON or OFF.

Standby Mode

If bObi is not cleaning and the power switch is left ON, she enters standby mode,

which uses a small amount of battery. When in standby mode, bObi beeps every

few minutes to remind you to charge her or to turn her OFF. Remember to turn the

power switch OFF when you are not using bObi to conserve her battery life.

Working Modes

There are three touch buttons on

top of bObi:

GO!, JUICE, and WAFFLE

These buttons will not work while

bObi is on her charging station.

To use these buttons, you must

rst move bObi from her charging

station manually or by using her

remote control.

GO!

The GO! button activates bObi’s default cleaning mode. In this mode, she will use

her programmed algorithm to mop, sweep, and vacuum the oor. To use this mode,

simply press the GO! button on top of bObi or on her remote.

WAFFLE

Wae cleaning mode can be used to clean up small spills of dry substances. In this

mode, bObi will clean an area of approximately 10 square feet (1 square meter) for

about 3 minutes before she stops and enters standby mode.

To have bObi clean a small area, press the WAFFLE button on bObi’s cover or on

her remote.

Clear away clutter and cords before letting bObi clean a room.

JUICE

The JUICE button tells bObi to stop cleaning and start searching for her charging

station. When she detects her charging station, she will dock herself and start juicing.

bObi’s main brush and vacuum motor do not work while in Juice mode.

bObi enters Juice mode automatically when her battery level falls below 15%.

Charging Station

Setting up bObi’s charging station

Position bObi’s charging station against

a wall on a hard at surface. Make

sure that there is at least 10 feet (3

meters) of open space in front of the

charging station and 2 feet (0.5 me-

ters) on either side of the station.

Plug the adapter into the charging

station. The nightlight on top of

the charging station will turn on.

The Sync button is located

on the back of the charging

station

10ft

(3m)

2ft (0.5m)

bObi can accidentally run over her adapter cord and get it tangled in her brush. Help

bObi avoid this by hiding the cord behind her station and securing it between the

charging station and the wall.

Syncing bObi with her charging station

If bObi can’t nd her charging station, the station and bObi are out of sync. To

synchronize their coding, follow these steps:

1. Bring bObi close to her charging station.

2. Disconnect the charging station from the adapter.

3. Set the power switch on bObi’s side to OFF.

4. Plug the adapter into the charging station.

5. Use the syncing tool to press and hold the sync button on the back of the

charging station.

6. While holding down the sync button, set bObi’s power switch to ON.

7. bObi will emit a series of chirps to indicate her charging station has been

synchronized.

8. If bObi remains silent, turn bObi and her charging station OFF, disconnect the

station from the adapter, and wait a few minutes before repeating the process

(restart from step 1).

Charging bObi

bObi is powered by a rechargeable battery. She will perform best if she fully charges

prior to her rst cleaning mission.

Manual charging using the charging station

1. Turn bObi ON and place her directly onto her plugged-in charging station.

2. Make sure bObi’s charging electrodes (on her front) make full contact with the

station’s electrodes.

3. To indicate that she is successfully connected, bObi ashes the middle orange

LED light on her cover. The charging station’s nightlight also ashes slowly.

4. When bObi is done juicing (approximately 4 to 5 hours), the ashing light on

her cover becomes solid and the charging station’s nightlight ashes faster.

Manual charging using the adapter

While bObi is OFF, plug her charging adapter directly into her side. The power inlet

is next to bObi’s ON/OFF switch. bObi will chirp, ash her cover lights, then chirp

again to let you know that she’s connected. Her center LED light will blink orange to

indicate that she is charging and turn solid orange when she’s fully juiced.

Automatic charging

bObi will automatically start searching for her charging station when her battery falls

below 15%. She will emit a series of chirps, stop her vacuum motor to preserve

energy, and light up the JUICE button on her cover. She will move around, make full

circles, and communicate with her station. When bObi detects her charging station,

she will move towards it, dock, and begin to charge.

You will know bObi is fully charged when the middle LED light on her cover stops

blinking and turns solid.

If bObi cannot nd her charging station, she will continue searching until her battery

runs out, at which point you can manually pick her up and connect her to her station

(see ‘Manual charging using the charging station’).

blOck

You can use bObi blOck to customize bObi’s cleaning zone by creating an invisible

boundary line that bObi will not cross. The barrier that blOck creates can help you

section o a room, protect delicate rugs, and keep bObi clear of fragile items in your

home.

blOck needs 4 AA batteries (not included). There are two buttons on the back of the

blOck. The ON/OFF button and the sync button.

Turning the blOck ON

1. Place batteries in the blOck.

2. Press the ON/OFF button on the back of blOck. The power light inside blOck

turns on, stays still for 10 seconds, and then blinks every 3 secs. This indicates

that blOck is ready to be used.

3. bObi blOck will automatically go into standby after 3 hours of use and must

be turned ON each time it is needed.

4. When battery levels are low, blOck ashes more quickly than normal to indi-

cate that it needs new batteries. To save on batteries, switch it OFF.

ON/OFF sync

power light

Page is loading ...

bObsweep NW604001SV User manual

bObsweep NW604001SV User manual

Related papers

Other documents