Siemens S2040B1200 Installation guide

Type
Installation guide

Siemens S2040B1200

This indoor load center is designed to protect against short circuits with the help of branch breakers. It has a maximum short circuit current rating of 100,000 AMPS RMS symmetrical, 120/240V~. The actual rating depends on the branch breakers installed in this panelboard and the main/feeder breaker, if any, installed ahead of this panelboard.

Suitable for use as service equipment when the main breaker is installed. The unused neutral bar terminals may be used to terminate equipment grounding wires in the combinations indicated for equipment.

To reset breakers with tripped handle position between "ON" and "OFF", move the handle to "OFF" then to "ON".

Siemens S2040B1200

This indoor load center is designed to protect against short circuits with the help of branch breakers. It has a maximum short circuit current rating of 100,000 AMPS RMS symmetrical, 120/240V~. The actual rating depends on the branch breakers installed in this panelboard and the main/feeder breaker, if any, installed ahead of this panelboard.

Suitable for use as service equipment when the main breaker is installed. The unused neutral bar terminals may be used to terminate equipment grounding wires in the combinations indicated for equipment.

To reset breakers with tripped handle position between "ON" and "OFF", move the handle to "OFF" then to "ON".

  • Page 1 1

Siemens S2040B1200 Installation guide

Type
Installation guide

Siemens S2040B1200

This indoor load center is designed to protect against short circuits with the help of branch breakers. It has a maximum short circuit current rating of 100,000 AMPS RMS symmetrical, 120/240V~. The actual rating depends on the branch breakers installed in this panelboard and the main/feeder breaker, if any, installed ahead of this panelboard.

Suitable for use as service equipment when the main breaker is installed. The unused neutral bar terminals may be used to terminate equipment grounding wires in the combinations indicated for equipment.

To reset breakers with tripped handle position between "ON" and "OFF", move the handle to "OFF" then to "ON".

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI