CURT 11551 Installation guide

Brand: CURT

Model: 11551

Category: Car kits

Type: Installation guide

CURT 11551 is suitable for use as either a weight-carrying or weight-distributing hitch. CURT 11551 has a gross load capacity of 1,500 pounds and a maximum tongue weight capacity of 150 pounds. CURT 11551 is intended for use with 3/8-inch bolts. CURT 11551 requires drilling during the installation process. CURT 11551 comes with a manufacturer's warranty covering defects in material and workmanship to the original purchaser.

Parts List

DESCRIPTIONPART NUMBERQTYITEM

HEX BOLT3/8 - 16 x 1 1/441

WASHER3/8"22

LOCK WASHER3/8"43

HEX NUT3/8 - 1644

FENDER WASHER3/8"25

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.



WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.



HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT

1-877-287-8634

HITCH WEIGHT: LBS.

INSTALL TIME

PROFESSIONAL: MINUTES

NOVICE (DIY): MINUTES

INSTALL NOTES:

INSTALLATION STEPS





Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,

Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of

this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or

consequential loss or damage.

1,500 150

82-86 NISSAN SENTRA

12/14/2012

11551

217254

1. Temporarily remove spare tire. This hitch will fit against the spare tire well and the steel bottom

surface of the rear bumper. The plastic bumper covering must be cut away for hitch bumper bracket

to fit directly against steel bumper.

2. Using hitch as a template drill (2) holes in the rear bumper and (2) holes in the spare tire well for 3/8" bolts.

3. Bolt hitch to vehicle using fasteners as shown. Make sure to use fender washers on inside of trunk floor.

4. Torque all 3/8" fasteners to 45 lb-ft.