1
4
5
2
3
QUICK START
HOLY STONE
Fully Charged battery for drone, 4 new ”AA” for transmitter
Eras Light ITC
Power on the transmitter and then the drone.
Power
HS110D
HS200D
TAIL
HEAD
UP
DOWN
Ascend
Turning
Direction
Forward
Backward
Move Left Move Right
Descend
Turn Left
Turn Right
Ascend and Descend.
Emergency Stop.
Phone Adapter(Not Included):
5V/1A or 5V/2A
Indicator
Email Support :
[email protected] (America)
[email protected] (Canada)
[email protected] (Europe)
HotLine Support :
+1(855)888-6699
ENGINE START/
LANDING
(Pic1)
(Pic2) (Pic3)
Place the drone on a level surface, make sure the tail of drone
faces the pilot. Then push the throttle level up then down to pair
the drone and transmitter
Press “Engine Start”(Pic1), propellers rotate at low speed, push
the left stick up (Slowly) to take off (Pic2), press “Engine Landing”
button (Pic1) again to land the drone,or push the right stick down
(Pic3) until drone touchs the ground, hold a few seconds to stop
the motors.
Only stop motors mid-flight in emergency situations when
doing so can reduce the risk of damage or injury.
Press the UP LEFT(Photo Function) and UP RIGHT(Flip Function)
button at the same time, the motors will stop immediately.
Red indicator is on when charging, and will be off when fully
charged.
Charging time depond on the phone Adapter’s rated power, it
takes about1-1.5 Hour to fully charge the battery.
For more details, please read the instruction
for use. And do not hesitate to contact us if
you need any support.
If you’re satisfied with our product or
service, please leave us a feedback and
review on our page.
/
