2. Danfoss
  3. 027H0431

Danfoss 027H0431 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Danfoss 027H0431 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
027R9798
027R9798
© Danfoss A/S (MWA), 2015-02 DKRCI.PI.HV0.H2.02 / 520H4036 1
Installation Guide
Protection cap (027H0431)
for ICAD actuator
• Install the protection cap by sliding it down over the
top of the ICAD actuator.
• Align the protection cap with the ICAD actuator.
Make sure that the top surface of the protection cap is
in the same angle as the top cover of the ICAD actuator.
• Push down the protection cap until you reach the
mechanical stop.
• To secure the protection cap, tie it to the connector
cables using the hole in the protection cap.
Slide down the protection cap
Use the back side
of the top cover as
guide when aligning
the guide pins of the
protection cap with
the guide rails of the
ICAD actuator.
Guide rail on the
ICAD actuator
Hole for securing
the protection cap
Guide pin on the
protection cap
2 DKRCI.PI.HV0.H2.02 / 520H4036 © Danfoss A/S (MWA), 2015-02
/