Danfoss Protection cap for ICAD 600/900/1200 (027H0431) Installation guide

Instructions

027R9798

Protection cap

for ICAD 600/900/1200

(027H0431)

Install the protection cap by sliding it down over the •

top of the ICAD actuator.

Align the protection cap with the ICAD actuator. •

Make sure that the top surface of the protection cap is

in the same angle as the top cover of the ICAD actuator.

Push down the protection cap until you reach the •

mechanical stop.

To secure the protection cap, tie it to the connector •

cables using the hole in the protection cap.

Slide down the protection cap

Use the back side

of the top cover as

guide when aligning

the guide pins of the

protection cap with

the guide rails of the

ICAD actuator.

Guide rail on the

ICAD actuator

Hole for securing

the protection cap

Guide pin on the

protection cap

Kurt M.

Sand

Digitally signed by Kurt M. Sand

DN: cn=Kurt M. Sand, o=IR Market

Support, ou=AC-AKIP,

Date: 2010.01.07 14:27:54 +01'00'