Blue Sea Systems 1002 Operating instructions

COMPRESSION

RING

CableClam Installation Instructions

PN 1001 / 1002 / 1003

1. Drill seal with a sharp drill the same size as the cable. Keep the hole wet during drilling.

The hole will be slightly smaller than the cable.

2. Use a sharp razor knife to slit the seal from its edge to the center hole

3. Fasten the deck ring and gasket to the surface.

4. Slip the compression ring onto the cable. Insert the cable through the slit of the seal.

Press the seal into the compression ring.

5. Screw the compression ring to the deck ring by tightening each screw a few turns

at a time. Do not overtighten the screws.

DECK

RING

GASKET

SEAL

CABLE

Blue Sea Systems

Bellingham, WA 98226 USA

p 360

738.8230

p 800.222.7617 USA and Canada

f 360

734.4195

www.bluesea.com

This manual is also suitable for

Download PDF