Amico Powered Cart User guide

  • Hello, I'm your chat assistant. I've reviewed the Quick Guide for the Amico Powered Cart with Standard Interface. This document outlines the initial setup and adjustment procedures, particularly focusing on the cart's automatic and manual height adjustment features. I'm prepared to answer your questions about initializing, setting the home position, and other aspects covered in this guide.
  • What should I do when initializing the cart for the first time?
    How do I set the cart's "Home" position?
    Is this quick guide enough for complete installation?
Powered Cart with Standard Interface
Quick Setup, Installation, and Adjustment Instructions
Automatic Height Adjustment
1. First Time Initializing:
Briefly plug the cart into the power outlet. The AC Power Indicator should illuminate (the may take up to 30 seconds).
After initializing the cart, the two arrow buttons (Figure 1) will begin to flash, indicating that the user must set the carts “Home”
(lowest) position.
2. Setting Home Position:
Hold the Down arrow to lower the carts worksurface until only the Down arrow is flashing.
Release the Down arrow and reverse direction to raise worksurface to desired position.
Medical Facility Responsibility
!
WARNING: This Quick Guide is not a replacement for the full manual. It is the responsibility of the end user to ensure all aspects
of the installation are covered by following the full manual.
NOTE: Inspect the cart integrity prior to beginning setup.
Battery Level
E F
1/2
1/4 3/4
Recovery
Figure 1
Powered Cart with Standard Interface
Quick Setup, Installation, and Adjustment Instructions
Manual Height Adjustment
Amico Accessories Inc. | 85 Fulton Way, Richmond Hill, ON L4B 2N4, Canada | www.amico.com
Toll Free Tel: 1.877.264.2697 | Tel: 905.763.7778 | Fax: 905.763.8587 | Email: [email protected]
Battery Level
E F
1/2
1/4 3/4
Recovery
Medical Facility Responsibility
!
WARNING: This Quick Guide is not a replacement for the full manual. It is the responsibility of the end user to ensure all aspects
of the installation are covered by following the full manual.
NOTE: Inspect cart integrity prior to beginning setup.
AC Power Indicator
1. First Time Initializing:
Briefly plug the cart into the power outlet. The AC Power Indicator should illuminate (this may take up to 30 seconds).
Figure 1
Manual Height Adjustment
DESCRIPTION:
PART NO:
SCALE:
DRAWN BY:
CHECKED BY:
SHT.
OF
DRAWING NO:
NTS
DATE:
DATE:
PROJECTION
www.amico.com
AA-QG-MOBILE-COMPUTER-WORKSTATION-HUMMINGBIRD-STANDARD-INTERFACE 09.11.2020
/