INSTALLATION GUIDE
Can be installed in 3/8” to
5/8” thick ceilings
Items Required
(Purchase separately)
Gloves and
Safety Glasses
Ladder Wire
Strippers
Wire
Cutters
Dimmer from the
Compatibility List
(if needed)
Power Drill
with a hole saw
attachment
Turn power OFF from the
electrical panel before the
installation.
Determine the location for the installation
and cut ceiling hole in accordance with
cut — hole dimensions. Use the template
inside the box to cut a hole in the ceiling.
Open the junction
box swing cover and
remove the appropriate
knockout(s).
12 3
Insert the junction box
through the opening.
Push mousetrap springs on the xture upwards and insert the
xture base into the mounting hole. Release the clips and the
xture will be pulled ush to the ceiling. The springs will rotate
back into position and hold the LED module tight to the ceiling.
78
456
Insert the
electrical supply
cable through the
knockout.
Using quick — connect push — in terminals,
connect the green ground wire to the green
wire terminal; black wire to the black wire
terminal; white wire to the white wire terminal.
Place all wiring and
connections back into the box
and close the cover. Connect
the driver to the light panel.
