ELECRAFT ES100 User manual

Hello! I have reviewed the assembly instructions for the ELECRAFT ES100 K4 Carrying Case. This document provides clear steps on how to prepare the foam inserts and securely place your K4 device inside the carrying case. I am ready to answer your questions about this document and the device.
What should I do before placing the K4 in the foam insert?

How to position K4 in the bottom foam insert?

What to do after placing the K4 in the foam?

When to zip the carrying case?

V11/2022

1. Remove the center cutout from the top and bottom protective foam insert.

2. Place your K4 in the bottom protective foam insert. The bottom insert has four square holes

for the K4 feet. Be sure to place your K4 so the front knobs match the protective foam insert

cutout.

V11/2022

3. Place the top half of the foam insert over the top of your K4. If placed correctly, the top

half of the foam insert will slide over the K4 easily.

4. Unzip the K4 canvas carrying case completely. Place your protected K4 in the opening.

5. Zip the carrying case completely closed before lifting the carrying case.

6. Replace the center cutouts in the protective foam inserts to maintain the shape of your

foam inserts when not in use.