2. Hagerco
  3. 277D - Privacy Door Guard

Hagerco 277D - Privacy Door Guard Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Hagerco 277D - Privacy Door Guard Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
277D PRIVACY DOOR LATCH
Installation Instructions
I-TA01049
Rev 2, Rev Date: 11/15/2019 Page 1 of 1
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com
1. Determine mounting height on door (Recommend 10” to 12” above the interior lever).
2. Place the latch on the frame so the bracket is offset from the frame 1/16” (See Figure 2).
3. Once the latch is in the desired position on the frame face, mark (3) holes for drilling (See Figure 1).
4. Center punch and drill (3) 5/32” pilot holes.
5. Install (3) sheet metal screws to secure the device.
6. Check to make sure the swing arm rotates to the closed position when the door swings completely closed. Also
verify that the door will open without issue when the swing arm is in the closed position.
Note: Frame reinforcement is recommended. When installing on a decorative snap-on frame, use Hager 277F reinforcement bracket.
TOOLS REQUIRED
DOOR & FRAME
MUST HAVE 1/8”
MAXIMUM GAP
FIGURE 2 (TOP VIEW)
FIGURE 1 (FRONT VIEW)
1/16” OFFSET FROM
FRAME EDGE
Read all instructions carefully before installing device.
OPEN POSITION
CLOSED POSITION
DOOR
/