QOLSYS QR0018-840 Quick start guide

IQ PANEL BATTERY REPLACEMENT

Remove retaining screw and back plate from the

panel, then unplug the battery.

Remove the battery retaining clip and screw.

Use a finger or thumb and pull up firmly on the

battery to remove.

Do NOT use a screwdriver or anything sharp that could

puncture the battery.

Do NOT pull on the battery cable to try and remove battery.

Place new battery into the battery slot (bottom

first) pushing down into place. To ensure easier

battery replacement in the future, do NOT use

adhesive tape. Screw down retaining bracket, plug

in battery and replace panel back plate.

STEP 1: DISCONNECT BATTERY STEP 2: REMOVE RETAINING CLIP

STEP 3: REMOVE OLD BATTERY STEP 4: INSTALL NEW BATTERY

Replacing the IQ Panel’s standard Li-Ion battery is easy. Please

follow the steps outlined below. Note: you should only attempt this

with factory authorized battery part number QR0018-840

FOR TECHNICAL SUPPORT OR QUESTIONS PLEASE CALL (855) 4-QOLSYS

IMPORTANT!

BEFORE YOU

BEGIN:

To avoid damage or voiding your warranty, you

must properly power down the IQ Panel before

you begin the steps below. See installation

manual for additional details if needed.

Settings Power Down

WAIT UNTIL

LED LIGHTS

ARE OFF