Gama Sonic GS-98T-WB Operating instructions

Brand: Gama Sonic

Model: GS-98T-WB

Type: Operating instructions

This manual is also suitable for

ROYAL SOLAR LAMP POST

US Patent # 7172307

Instruction Manual

Models: GS-98L, GS-98S

GS-98D, GS-98T, GS-98W, GS-98P,

Introduction

Thank you for your purchase.

GAMA SONIC

® solar charged accent lighting eliminates

the problems associated with most solar lighting available today.

GAMA SONIC

® solar

charged lights are brighter and last all night with a typical solar charge. Unique

design, superior light output and numerous installation options confirm the

outstanding value of the product.

GAMA SONIC

® has been recognized as a worldwide leader in the lighting industry for

over 20 years. The company also offers unique multi-purpose rechargeable products

that range from party lights to emergency lighting products.

For technical assistance and more information call our Toll Free number:

800-835-4113 (only within the US) or visit our website at:

www.gamasonic.com.

Please read the instruction manual carefully to obtain the best results from your

purchase.

Unpack and identify the following components.

Tools that are needed but not supplied with the high post lamps are: a screw driver, a

wrench and an electrical drill that will be used to anchor the lamp base to the ground.

Solar Lamp Post Location

For optimum light duration throughout the night, it is very important to mount your

solar lamp post in a spot where it will receive the maximum amount of sunlight

throughout the day.

NOTE: The following steps are for reference only. Consult your local hardware store

for the best installation method for your particular surface.

NOTE: The solar light must be charged for two sunny days for best results.

Operation Instructions for all models

1. Unscrew the two knobs in the upper part of the lamp (B) to detach it

from Part A.

2. Turn ON the operation switch by choosing your desired brightness

level: Low (I) - last longer using dimmer light. High (II)- Brighter

light output. (Fig. 1).

3. Reassemble the upper part of the lamp (B) by screwing the two knobs.

FIG. 1

Installation Instructions for models GS-98L\S\D\T

1. Mark and drill three holes, using the triangle marker (included), into a

solid surface no smaller than the fastening screws. The holes shall be

lined up with the holes of the lamp base (D).

2. Put the fastening screws (included) into the drilled holes with their

threaded ends facing up (Fig. 3).

3. Place lamp base onto fastening screws and secure base with the nuts

using a wrench (Fig 4).

4. Make sure the lamp base (D) is stable before installing Part (E).

5. Place part (E) on top of part (D) and tighten with the provided screws

using a wrench.

6. GS-98L:

6.1 Screw part (F) onto part (E).

6.2 Place Part (A) on top of Part (F) and tighten the 3 screws.

7 GS-98S:

7.1 Screw part (G) onto part (E) and part (F) onto part (G).

7.2 Place Part (A) on top of Part (F) and tighten the 3 screws.

8. GS-98D\GS-98T:

8.1 Screw part (G) onto part (E).

8.2 Screw Part (H) onto Part (G).

8.3 Place bracket (I) into part (H) and tighten the knob from within

Part (H), then screw the second screw from outside Part (I) to

secure the bracket to part (H).

8.4 Repeat steps (8.3) two times in model GS-98D and three times

in model GS-98T.

8.5 Install part (J) on top of Part (H) by screwing the two screws.

GS-98S/D/T GS-98L

Fig. 4

Fig. 3

GS-98P

Use electric drill to make two holes in the desired surface, place provided

anchors into holes, place the base (L) in line with the holes and screw the

provided screws.

GS-98F

NOTE: If you are replacing an existing gas/electric post light, you must consult a

certified technician to cancel them before installation.

Place Part (M) on top of your existing 3” post and tighten the 3 screws

provided to secure the lamp.

GS-98W

NOTE: locate your solar lamp facing the south for best results.

Use electric drill to make two holes in the wall, place provided anchors into

holes, place the wall bracket (N) in line with the holes and screw the provided

screws.

Replacing the Batteries

(After several years of use, the batteries may need replacing).

1. Unscrew the two knobs in the upper part of the lamp (B) to detach it

from Part A.

2. Make sure the ON/OFF switch is in the “OFF” position (0).

3. Unscrew the battery compartment’s screw located on the silver reflector

and remove the old battery pack. Make sure the new batteries are high

quality – 1 x Li-Ion Battery Pack (3.2 Volt / 1500 Ma) (Fig. 1).

4. Install the new batteries into the battery compartment.

5. Reassemble the unit by reversing the above procedure.

Charging & Duration Chart

WARNING: Do not dispose of Li-Ion battery in the regular trash, municipal waste

stream or by fire as batteries may leak or explode. Do not open, short circuit, or

mutilate batteries as injury may occur. Preserve our environment by recycling Li-Ion

batteries or disposing of them in accordance with local, State and federal regulations.

Do not mix old and new batteries.

Model#

Charging

Time

Duration

High Mode

Duration

Low Mode

GS-

98L/S/D/T/W/F/P

3 Hours Approx. 6 hours Approx. 8 hours

6 Hours Approx. 10 hours Approx. 15 hours

Maintenance

Clean the solar panel regularly with a damp towel to guarantee optimum performance

of the solar panel. Do not use any type of solvent for cleaning and be careful not to

put too much pressure on the solar panel while cleaning.

Trouble Shooting

If your solar charged light does not come on at dusk despite observance of all the

instructions, please try the following steps:

1. Make sure that the solar lantern is not being affected by any other light

source.

2. Ensure the solar lantern is not positioned in the shade during the day.

3. Make sure the switch in the lamp head is in the “ON” position (either

Low “I” or High “II”).

4. Check that the batteries are installed correctly.

NOTE: The performance of the solar light will vary with the time of year. It will

deliver more light when it has had a full day in the sun rather than a day in overcast

weather.

WINTERTIME TIPS: For optimal performance, be sure to remove any snow or

debris accumulation from solar panel(s). A solar panel free of debris will charge the

batteries much more efficiently.

WARNING: Please keep out of reach of children.

Gama Sonic GS-98T-WB Operating instructions

Brand: Gama Sonic

Model: GS-98T-WB

Type: Operating instructions

This manual is also suitable for

Download PDF

report

Gama Sonic GS-98T-WB Operating instructions

This manual is also suitable for

Gama Sonic GS-98T-WB Operating instructions

Related papers

Other documents