Chief NAXS15VM Installation guide

Category
Projector mounts
Type
Installation guide

Chief NAXS15VM is a vertical mount surge protector designed for use with 19-inch wide equipment racks, providing protection for your valuable electronic devices. With a 15 Amp capacity, it's ideal for powering smaller systems or individual components. Easy to install with the included 10-32 x 3/4" header point Phillips screws, it ensures a secure and reliable connection within your rack. The NAXS15VM safeguards your equipment from voltage spikes and surges, giving you peace of mind and extending the lifespan of your devices.

Chief NAXS15VM is a vertical mount surge protector designed for use with 19-inch wide equipment racks, providing protection for your valuable electronic devices. With a 15 Amp capacity, it's ideal for powering smaller systems or individual components. Easy to install with the included 10-32 x 3/4" header point Phillips screws, it ensures a secure and reliable connection within your rack. The NAXS15VM safeguards your equipment from voltage spikes and surges, giving you peace of mind and extending the lifespan of your devices.

INSTALLATION INSTRUCTIONS
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Vertical Mount Surge Protectors
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
NAXS15VM/20VM
NAXS15VM/20VM Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
DIMENSIONS
18.81
477.7
10.65
270.5
SURGE-X SXVM1115RT
17.38
441.3
SURGE-X SXVM1115RT
SURGE-X SXVM1120RT
SURGE-X SXVM1120RT
DIMENSIONS: [MILLIMETERS]
INCHES
Installation Instructions NAXS15VM/20VM
3
TOOLS / HARDWARE / PARTS
ASSEMBLY AND INSTALLATION
NOTE: The NAXS15/20VM vertical mount surge protectors are
designed for use with 19" wide equipment racks. See
the specific installation instructions provided with the
rack for additional installation information.
NOTE: The NAXS15VM is used for 15 Amp systems and
NAXS20VM is used for 20 Amp systems. The
dimensions of the two products are the same.
1. Attach the surge protector (A) within the rack, using four
10-32 x 3/4" header point Phillips screws (B).
(See Figure 1)
2. Complete the installation following the rack installation
instructions.
Figure 1
A (1)
[Surge protector]
B (4)
10-32 x 3/4"
(A)
1
(B) x 4
(NE1F2023 rack shown as example)
NAXS15VM/20VM Installation Instructions
USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378
P 800.582.6480 / 952.894.6280
F 877.894.6918 / 952.894.6918
Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands
P +31 (0)40 2668620
F +31 (0)40 2668615
Asia Pacific A Office No. 1 on 12/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P 852 2145 4099
F 852 2145 4477
Chief Manufacturing, a products division
of Milestone AV Technologies
8821-002008 Rev00
2010 Milestone AV Technologies, a
Duchossois Group Company
www.chiefmfg.com
09/10
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Chief NAXS15VM Installation guide

Category
Projector mounts
Type
Installation guide

Chief NAXS15VM is a vertical mount surge protector designed for use with 19-inch wide equipment racks, providing protection for your valuable electronic devices. With a 15 Amp capacity, it's ideal for powering smaller systems or individual components. Easy to install with the included 10-32 x 3/4" header point Phillips screws, it ensures a secure and reliable connection within your rack. The NAXS15VM safeguards your equipment from voltage spikes and surges, giving you peace of mind and extending the lifespan of your devices.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI