Addendum (7’ 6” Door Stop)
Addendum
Addendum (7’ 6” Door Stop)
This Machine is equipped 7’6” Infeed & Outfeed Door Stop Shift. This assembly is calibrated.
See the next page for the Calibration screen layout.
Select the 7’ 6” Door Length button. The machine will move the Jamb and
Door Stop assemblies to the corresponding positions. The figure below
shows the location of the stops and an inset photo of positions of a right
hand door setting.
The left hand door settings are located at the Out Feed of the Machine and
are the mirror image of the right hand door settings.
Left Hand Door Stops: The
positioning is the mirror
image of the Right Hand
Stops
Right Hand Door
Stops
Jamb Stop
Door Stop
Addendum (7’ 6” Door Stop)
Addendum
Main Screen
For full descriptions of the screen choices, see “About the Main Screen” on page 2-43 of the 994-
X Operation Manual.
Note: A machine with this option cannot run the ball catch process at the 7’ 6” loca-
tion. See the Error Message below. When the popup is closed, the ball catch
automatically turns off.
Calibration Screen
For full descriptions of the screen choices, see “About Calibration” on page 3-2 in the 994-X Oper-
ation Manual. For this option, the calibration routine includes the 7’ 6” Lock Location.
/
