Page is loading ...
REMOTE DISPL AY ELECTRIC SCALE
330-LB. CAPACITY
OWNER’S MANUAL
WARNING:
Read carefully and understand RULES FOR SAFE OPERATION and instructions before
operating. Failure to follow the safety rules and other basic safety precautions may result in
serious personal injury.
Item #19399
Page
2 of 3
Thank you very much for choosing a NORTHERN TOOL + EQUIPMENT CO., INC., Product! For
future reference, please complete the owner’s record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire manual to
become familiar with this product before you begin using it.
This machine is designed for certain applications only. Northern Tool + Equipment strongly
recommends this machine is not modified and/or used for any application other than that for which it
was designed. If you have any questions relative to a particular application, DO NOT use the
machine until you have first contacted Northern Tool + Equipment to determine if it can or should be
performed on the product.
For technical questions and replacement parts, please call 1-800-222-5381.
SPECIFICATIONS:
1. Capacity: 330 LBS.
2. Graduation: 0.2 LB.
3. Use temperature: 50°~104°
4. Environmental humidity: <80%
5. Low power indicator: (Low)
6. Over load indicator: (Err)
7. Automatic switch off
8. Power supply: 2 x CR2032 batteries (included)
OPERATION:
1. Before using the scale, remove the white insulation strip from the battery holder.
2. The scale is preset at “LBS.” If you want to change to “KG,” turn the switch on the back of
handheld display to “KG” (See Fig. 1).
FIG. 1
3. Place the scale on a firm, flat surface to achieve best accuracy.
4. Press either one of the 2 “ON/OFF” buttons on the handheld display (See Fig. 2).
FIG. 2
Turn the switch on the
back of handheld display
to select “LBS” or “KG”
Both buttons are on/off
switches. Press either one
to turn on/off the scale.
Page
3 of 3
5. When the display shows “0.0,” place a load on the scale pan to weigh. The weight value will be
locked in and flash 3 times before automatically shutting off. If there is no load on the scale pan
after the scale shows “0.0,” the scale will turn off automatically after 10 seconds.
WARNING!
1. The scale will be slippery when wet. Keep it dry!
2. This product can only be used by static pressure. Avoid damaging the unit by striking, shocking
or dropping it.
3. Keep the scale in horizontal position.
4. Intended for light-duty use; do not use for commercial purpose involving items heavier than 330
lbs.
5. Treat scale carefully. Do not drop it or jump on it.
MAINTENANCE:
1. Clean scale with a damp cloth but avoid getting water inside the scale. Do not use chemical
cleaning agents. The scale should not be soaked in water.
2. Keep your scale in a cool, dry place; do not expose the scale to heat or humidity.
WARNING
Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains
chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment,
such as those dust masks that are specially designed to filter out microscopic particles.
Northern Tool + Equipment Co.,
2800 Southcross Drive West
P.O. Box 1499 Burnsville, MN 5337-0499
Made in China.
/
