Radiant Communications DL227 User manual

Radiant Communications
Brand
Radiant Communications
Model
DL227
Category
Network media converters
Type
User manual

Radiant Communications DL227 is a Gigabit Ethernet converter that allows you to connect your devices over long distances using fiber optic cables. It supports both multimode and single-mode fiber, and can transmit data at speeds of up to 1000Mbps. The DL227 is also equipped with a number of features that make it easy to use and manage, including auto-negotiation, automatic polarity detection, and full-duplex operation.

Here are some of the possible use cases for the Radiant Communications DL227:

  • Connecting two buildings or offices that are located far apart
  • Extending the reach of your network to remote devices, such as security cameras or access points

Radiant Communications DL227 is a Gigabit Ethernet converter that allows you to connect your devices over long distances using fiber optic cables. It supports both multimode and single-mode fiber, and can transmit data at speeds of up to 1000Mbps. The DL227 is also equipped with a number of features that make it easy to use and manage, including auto-negotiation, automatic polarity detection, and full-duplex operation.

Here are some of the possible use cases for the Radiant Communications DL227:

  • Connecting two buildings or offices that are located far apart
  • Extending the reach of your network to remote devices, such as security cameras or access points
SERIES DL227
10/100/1000M FIBER OPTIC TRANSCEIVER
USER MANUAL
Radiant Communications Corporation
P.O. BOX 867 • 5001 Hadley Road • South Plainfield, NJ 07080
800.969.3427 • Fax 908.757.7666
E-mail: [email protected]om • www.rccfiber.co
RADIANT COMMUNICATIONS CORP. DL227 REV B 12/05
1
DL227 SERIES REV B – User Manual
Description:
The DL227 Rev B converter is an IEEE 802.3ab compliant Gigabit Ethernet 1000Base-T
unshielded twisted pair (UTP) to 1000Base-Sx or 1000Base-Lx fiber converter.
It features Auto-Negotiation which allows it to auto-adapt to the full/half duplex and flow
control services as well as data rate (10/100/1000M) supported by the device connected
to its 1000Base-TX port.
The 1000Base-TX port uses a modular EIA/TIA 568 RJ45 connector and supports
category 5 or higher wiring with distances of up to 100m. (328ft.). Automatic polarity
detection and correction assists in network installation and maintenance.
The DL227 Rev B operates in full-duplex. This feature maximizes the throughput when
connecting to height bandwidth full-duplex devices such as servers or switches.
Troubleshooting:
Power LED not lit- Check A/C power cord connections to and from unit.
Data Link LED not lit- Check Cat. 5 cable connections. Check Cat. 5 cable. Ensure the
port on connecting device is enabled.
Optical Link LED not lit- Check light levels against spec. label. Check optical budget.
NOTE – 1000MBS LED IS ONLY LIT WHEN PORT ON CONNECTING DEVICE
IS SET AT 1000MBS. FDX LED IS ONLY LIT WHEN PORT ON CONNECTING
DEVICE IS SET FOR FULL-DUPLEX.
SPECIFICATIONS
Protocol: IEEE 802.3ab, 1000Base-T. 1000Base-X
Connectors and Cables:
Twisted Pair UTP: RJ45, Category 5 or higher
Fiber: SC, SC/APC
Multimode: 50/125, 62.5/125 μm
Single-Mode: 9/125 μm
Twisted Pair UTP Distance: 100 m/ 328 ft.
Fiber Distances: Check with factory
RADIANT COMMUNICATIONS CORP. DL227 REV B 12/05
2
LEDs: POWER, DATA LINK, OPTICAL LINK,
1000MBS, FDX
Dimensions: W 16” x D 12” x H 1.75”
Power: 110-240VAC .65A 50/60Hz
Temperature:
Operating: 0˚ to 70˚ C
Storage: -40˚ to 80˚ C
Humidity: 0-90% (non-condensing)
ORDERING INFORMATION
Part Number Description Wavelength # of Fibers Max Optical Atten.
62um 9um
Approx.
Dist.
DL227/MM-X: Media
Converter
850nm 2 10db _ 0-2Km
DL227/SM-X:
Media
Converter
1300nm 2 _ 10db 0-25Km
DL227A/SM-X: Media
Converter
1310nm 1 _ 10db 0-25Km
DL227A/SMHP-
X:
Media
Converter
1310/1550nm 1 _ 18db 0-50Km
Radiant Communications Corporation
P.O. BOX 867 • 5001 Hadley Road • South Plainfield, NJ 07080
800.969.3428 • Fax 908.757.7666
E-mail:
[email protected] • www.rccfiber.com
RADIANT COMMUNICATIONS CORP. DL227 REV B 12/05
3
  • Page 1 1
  • Page 2 2
  • Page 3 3

Radiant Communications DL227 User manual

Radiant Communications
Brand
Radiant Communications
Model
DL227
Category
Network media converters
Type
User manual

Radiant Communications DL227 is a Gigabit Ethernet converter that allows you to connect your devices over long distances using fiber optic cables. It supports both multimode and single-mode fiber, and can transmit data at speeds of up to 1000Mbps. The DL227 is also equipped with a number of features that make it easy to use and manage, including auto-negotiation, automatic polarity detection, and full-duplex operation.

Here are some of the possible use cases for the Radiant Communications DL227:

  • Connecting two buildings or offices that are located far apart
  • Extending the reach of your network to remote devices, such as security cameras or access points
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents