†
Check local codes for required breaker size.
Note: Cabinets installed adjacent to wall ovens
must have an adhesion spec of at least 194°
temperature rating. This model is NOT approved
for stackable or side-by-side installation.
Installation information: Before installing, consult
installation instructions packed with product for
current dimensional data.
Dimensions and Installation Information (in inches)
For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
ge.com or call GE Answer Center
®
service,
800.626.2000.
JRP20WJ/BJ
GE
®
24" Built-In Single Oven
KW Rating
240V
3.4
208V
2.6
Breaker Size
20 Amps
†
Listed by
Underwriters
Laboratories
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Specification Revised 7/05
320304
C
L
2 x 4 or
equivalent
runners
Suitable
bracing
to support
runners
11"
over centerline
of cabinet
2" x 4"
or equiv.
runners
23-1/2 Min.
22-1/2 Min.
Conduit 49" long
6015 Built-in Single Oven
(Pub. 1-G003 pg. 107) April 28, 1993
32-1/2
27-5/8
10
24
Allow 3/4"
for overlap
over all edges
of cutout
Locate
unction box
either 5" MIN.
below cutout
floor or 44"
MIN. above
cutout floor
Minimum
cutout location
from floor
25-1/8
23-3/4
28-1/4
20