EDEN
| E SERIES HEAD |
ENGLISH - 4
E300 Front Panel Navigation:
1. Illuminated Eden logo - Illuminates when unit is switched on.
2. Line Out - Connect your amplifier to an external recording
device or to a mixing desk console.
3. Input - Connect your instrument here.
4. Gain - Controls the preamp volume (gain) of your amplifier.
5. Set Level LED - Indicates that the compressor circuit is active.
6. Enhance - Eden tailored EQ modifier adjust this to change your
overall EQ shaping.
7. Bass - Set at 12 o'clock this EQ provides a perfect flat Bass EQ
setting to the left will reduce the lower frequencies while turning to
the right will increase the lower frequencies.
8. Mid - Set at 12 o'clock this EQ provides a perfect flat Mid EQ
setting to the left will reduce the Mid frequencies while turning to
the right will increase the Mid frequencies.
9. Treble - Set at 12 o'clock this EQ provides a perfect flat High
EQ setting to the left will reduce the High frequencies while turning
to the right will increase the High frequencies.
10. Master - Controls the overall volume of your amplifier.
11. Aux In - Connect your CD player or other device here.
12. Phones - Insert standard headphones here for silent practice.
13. MP3 In - Connect your MP3 here using a 3.5mm jack plug.
14. Power Switch - Switch your unit off or on using this switch.
E300 Rear Panel Navigation:
1. AC Inlet - Connect your power cord here.
2. Speaker Output - Connect your speaker cable here.
E300 Quick Start Guide
The E300 produces 300 watts of pure power into 4 ohms (175 watts into 8 ohms) with 3dB of dynamic headroom. The preamp
section, with it's Enhance control, powerful tone control system and gentle auto-compression circuit allows you to achieve a wide array
of sounds.