Western Speed Control Installation guide

Category
Motorcycle Accessories
Type
Installation guide
Speed Control with Adapter Installation Instructions
Copyright© 2000 Douglas Dynamics, L.L.C. All rights reserved. This material may not be reproduced or copied, in whole or in part, in any printed,
mechanical, electronic, film or other distribution and storage media, without the written consent of the company. Authorization to photocopy
items for internal or personal use by the companys outlet is granted.
The company reserves the right under its product improvement policy to change construction or design details and furnish equipment when so
altered without reference to illustrations or specifications used herein.
March 21, 2000
Lit. No. 94518
Installing the Adapter
1. Connect the red and white plug on the adapter
harness to the red and white plug on the back of the
control.
2. Connect the black plug on the adapter harness to
the remaining black plug on the back of the control.
3. After these two plugs are connected, connect the
reamaining wires in the adapter harness to the
corresponding control harness wires.
9027-1, 9390-1
66600-1, 67070-1
+
_
Battery
Fuse
Fuse holder
Ring Terminal
Harness
Control
Black
White
Butt
Connector
Red
Power Lead
Black
Ground Lead Spreader
Receptacle
Existing wiring not
included with this kit.
Speed
Control
Adapter
Harness
Printed in USA
  • Page 1 1

Western Speed Control Installation guide

Category
Motorcycle Accessories
Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI