Ohlins 35020-17 Mounting Instruction
- Category
- Car kits
- Type
- Mounting Instruction
Cancellation Kit, Audi R8
35020-17
Mounting Instructions
Note!1
Please note that there can be small differences
between your product and the images in
these instructions.
Kit Contents
Description Part No Pcs
Cable ties 3,5x190 10
Cable ties with edge clip 6
Adhesive clip bracket 3
Cancellation component 4
2
MOUNTING INSTRUCTIONS
Front axle:
Left vehicle side
1
Run the original shock absorber cable along
the marked point and x it on the chassis
with the supplied adhesive clips (1) and edge
clips (2). Insert the standard connector into
the Cancellation component connector until
it locks. Pay attention the a correct cable
running.
Warning!⚠
It is advisable to have an Öhlins dealer install
the EDC Cancellation Kit.
Warning!⚠
If you work with a lifted vehicle, make sure that it
is safely supported to prevent it from tipping over.
Right vehicle side
2
Run the original shock absorber cable along
the marked point and x it on the original wire
harness with the supplied cable ties (3). Insert
the standard connector into the Cancellation
component connector until it locks. Pay
attention the a correct cable running.
2
2
1
1
3
3
3
3
MOUNTING INSTRUCTIONS
Rear axle:
Right vehicle side
3
Run the original shock absorber cable along
the marked point and x it on the original wire
harness with the supplied cable ties (1). Fix
the Cancellation component with edge clips (2)
on the chassis. Insert the standard connector
into the Cancellation component connector
until it locks. Pay attention the a correct cable
running.
Left vehicle side
4
Run the original shock absorber cable along
the marked point and x it on the original wire
harness with the supplied cable ties (1). Fix
the Cancellation component with edge clips (2)
on the chassis. Insert the standard connector
into the Cancellation component connector
until it locks. Pay attention the a correct cable
running.
2
2
1
1
1
2
1
Öhlins Racing AB
Box 722
S-194 27 Upplands Väsby, Sweden
Phone +46 8 590 025 00
fax +46 8 590 025 80
© Öhlins Racing AB. All rights
reserved. Any reprinting or
unauthorized use without the written
permission of Öhlins Racing AB
is prohibited.
Öhlins products are subject to
continuous improvement and
development, therefore, although
these instructions include the most
up-to-date information available at
the time of printing, minor updates
may occur.
To nd the latest information
contact an Öhlins distributor.
Please contact Öhlins if you have
any questions regarding the
contents in this document.
Part no. MI_35020-17_0
Issued 2017-03-30
-
1
-
2
-
3
-
4
Ohlins 35020-17 Mounting Instruction
- Category
- Car kits
- Type
- Mounting Instruction
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Ohlins 35020-03 Mounting Instruction
-
-
-
-
-
-
-
-
-