BMW M3 F80, M4 F82 EDC Cancellation Kit
35020-02
Mounting Instructions
Note!
Please note that this image is a general representation
of the product and may differ slightly from your product.
Kit Contents
Description Part No Pcs
Cable ties 4,5x300 6
Cable ties 3,5x190 4
Cable ties edge clip
4,5x190
2
Screw M8 6
Connector 4
Cover 2
Seal 2
Cancellation kit 4
2/4
Front axle and rear axle:
1
Open the connector lock. Remove the
standard wire out of the connector.
MOUNTING INSTRUCTIONS
Warning!
It is advisable to have an Öhlins dealer install the EDC
Cancellation Kit.
Warning!
If working on a raised vehicle, ensure it is securely
supported.
Connector lock
2
Insert the completted wire with sealings into
the supplied connector. The pin position/
cable colour is not relevant. After this lock the
connector by bringing back the plastic part in
the picture above in the direction of the arrow
“Connector cover”.
3/4
MOUNTING INSTRUCTIONS
Front axle:
Fix the front cancellation kit with the supplied
cable ties on the wire harness. Insert the
standard connector into the cancellation kit
connector until it locks. Fix the wire with cable
ties on the wire har-ness.
Rear axle
Kit includes seals, covers and screws. These
are absolutely required for the istallation. The
original seal, cover, and the distance is no
longer necessary.
2x Seal 2x Cover
6x Screws
Öhlins Racing AB
Box 722
S-194 27 Upplands Väsby, Sweden
Phone +46 8 590 025 00
fax +46 8 590 025 80
© Öhlins Racing AB. All rights
reserved. Any reprinting or
unauthorized use without the written
permission of Öhlins Racing AB
is prohibited.
Öhlins products are subject to
continuous improvement and
development, therefore, although
these instructions include the most
up-to-date information available at
the time of printing, minor updates
may occur.
To nd the latest information
contact an Öhlins distributor.
Please contact Öhlins if you have
any questions regarding the
contents in this document.
Part no. MI_35020-02_0
Issued 2016-04-29
Updated 2018-09-21
Rear axle - left:
Fix the rear cancellation kit with the supplied
edge clips on the bracket as shown in the
picture. Insert the standard connector into the
cancellation kit connector until it locks. Fix the
wire with cable ties on the wire harness.
Rear axle - right:
Fix the rear cancellation kit with the supplied
cable ties on the wire harness as shown in the
picture. Insert the standard connector into the
cancellation kit connector until it locks. Fix the
wire with cable ties on the wire harness.
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Ohlins 35020-05 Mounting Instruction
-
-
-
-
-
-
-
-
-