EHEIM 250 Owner's manual

Page is loading ...

Pflege und Wartung

H/I Netzstecker ziehen und Pumpenkopf abnehmen. Verriegelung am

Pumpenkopf lösen und Pumpenteile entsprechend der Zeichnung

herausnehmen. Kühlkanal-Einsatz I mit Schraubenzieher aushe-

ben. Alle Teile mit EHEIM Reinigungsbürste für Pumpenkammer

(Best.-Nr. 4009550) reinigen. Anschließend in gleicher Reihenfolge

wieder zusammensetzen.

Hinweis: Die kompletten Schlauchverbindungen in regelmäßigen

Abständen auf korrekten Sitz prüfen.

Achtung: Achse im Lagerkörper – und der darauf aufgesetzte Pum-

penflügel – müssen absolut leichtgängig sein, damit die Pumpe

einwandfrei anläuft.

IMPORTANT SAFETY INSTRUCTIONS

WARNING – To guard against injury, basic safety precautions should

be observed, including the following.

a)

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS.

b) DANGER – To avoid possible electric shock, special care should be

taken since water is employed in the use of aquarium equipment. For

each of the following situations, do not attempt repairs by yourself;

return the appliance to an authorized service facility for service or dis-

card the appliance.

1) If the appliance falls into the water,

DON’T reach for it! First un-

plug it and then retrieve it. If electrical components of the appliance

get wet, unplug the appliance immediately. (Non-immersible equip-

ment only)

2) If the appliance shows any sign of abnormal water leakage, im-

mediately unplug it from the power source. (Immersible equipment

only).

3) Carefully examine the appliance after installation. It should not be

plugged in if there is water on parts not intended to be wet.

4) Do not operate any appliance if it has a damaged cord or plug, or

if it is malfunctioning or has been dropped or damaged in any man-

ner.

5) To avoid the possibility of the appliance plug or receptacle getting

wet, position aquarium stand and tank to one side of a wall-mounted

receptacle to prevent water from dripping onto the receptacle or plug.

A ”drip-loop”, shown in the figure, should be arranged by the user for

each cord connecting an aquarium appliance to a receptacle. The

”drip-loop” is that part of the cord below the level of the recep-

tacle, or the connector if an extension cord is used, to prevent water

traveling along the cord and coming in contact with the receptacle.

INSTRUCTIONS 2213

If the plug or socket does get wet, DON’T unplug the cord. Discon-

nect the fuse or circuit breaker that supplies power to the appliance.

Then unplug and examine for presence of water in the receptacle.

c) Close supervision is necessary when any appliance is used by or near

children.

d) To avoid injury, do not contact moving parts or hot parts such as

heaters, reflectors, lamp bulbs, and the like.

e) Always unplug an appliance from an outlet when not in use, before

putting on or taking off parts, and before cleaning. Never yank cord to

pull plug from outlet. Grasp the plug and pull to disconnect.

f) Do not use an appliance for other than intended use. The use of at-

tachments not recommended or sold by the appliance manufacturer

may cause an unsafe condition.

g) Do not install or store the appliances where it will be exposed to the

weather or to temperatures below freezing.

h) Make sure an appliance mounted on a tank is securely installed before

operating it.

i) Read and observe all the important notices on the appliance.

j) If an extension cord is necessary, a cord with a proper rating should

be used. A cord rated for less amperes or watts than the appliance

rating may overheat. Care should be taken to arrange the cord so that

it will not be tripped over or pulled.

k) This appliance has a polarized plug (one blade is wider than the

other).

As a safety feature, this plug will fit in a polarized outlet only one way.

If the plug does not fit fully in the outlet, reverse the plug. If it still does

not fit, contact a qualified electrician. Never use with an extension

cord unless plug can be fully inserted. Do not attempt to defeat this

safety feature.

Exception: This instruction may be omitted for an appliance that is not

provided with a polarized attachment plug.

l)

”SAVE THESE INSTRUCTIONS”.

AQUARIUM

TANK

POWER

SUPPLY

CORD

DRIP

LOOP

APPLIANCE

English

Many thanks

for purchasing your new EHEIM classic external filter. It gives you op-

timum performance with excellent reliability and great effectiveness.

Safety instructions

For indoor use only. For use with aquariums.

All electrical equipment in the water must be disconnected from the mains

during care and maintenance work. It is imperative to disconnect the filter

from the mains prior to opening it.

The connecting line of this device can not be replaced. When the line is

damaged, the device must no longer be used.

Contact your specialised dealer or your EHEIM Service Centre.

This equipment is not intended for use by persons (including children) with

limited physical, sensory or mental abilities or for persons with no experi-

ence or knowledge unless they are supervised by a person responsible for

safety or unless they have received from such a person instructions on how

to use the equipment.

Children should be supervised to ensure that they do not play with the

equipment.

Notice: These divices produce magnetic fields which might

cause electronic and mechanical disturbances or damages.

This also refers to pacemakers. Please consult the manuals of medical

equipment for the required safety margins.

Attention: Maintenance work presents the risk of crushing the fingers due to

high magnetic forces.

For your own safety, we recommend to form a drip loop

with the connection cable to prevent any water running

along the cable from intruding into the socket.

When using a multiple socket or an external power sup-

ply unit, position them atop the filter’s power connec-

tion.

Since a wide variety of varnishes and polishes are used

when processing timer, the appliance feet can leave

visible traces on furniture or parquet floors as a result

of chemical reactions. Therefore the device should not

be placed on unprotected wooden surfaces.

To achieve optimal operational safety there must be a

maximum of 180 cm between the surface of the water

and the bottom of the filter.

Attention: Filter must always be operated in an upright

position only.

Take the necessary precautions when handling components that can dis-

charge static electricity.

Do not clean the unit – or parts of it – in the dishwater. Not dishwater resi-

stant!

Do not dispose of this product as normal household waste. Take it to your

local refuse collection side.

The product is qualified in

accordance with the respective

national regulations and guidelines

and meets EC standards.

20 cm

geprüfte

Sicherheit

max.

180 cm

External filter 2213

Function

A



Pump head



filter canister



pressure side hose connection



suction side hose connection



filter media container



suc-

tion pipe



strainer



suction cups with clips



outlet elbow



outlet pipe.

B Extract the filter media container with the handle and open the lid

by turning it anti-clockwise.

B

1 Model with filter pads: Rinse all filter pads under running water

and insert them into the filter media container according to the

drawing: 5 coarse filter pads blue (order no. 2616131 / 3 pcs.),

1 fine filter pad white (order no. 2616135 / 3 pcs.), and 1 car-

bon filter pad black (order no. 2628130 / 3 pcs.) as a top layer. The

carbon filter pad adsorbs possible dissolved harmful substances

after newly installing the filter. After a working time of approx. two

weeks, the carbon filter pad should be removed.

B

2 Model with filter media: Fill the filter media container in the fol-

lowing order: approx. 3-5 cm EHEIM MECH, 1 coarse filter

pad blue (order no. 2616131 / 2 pcs.), EHEIM SUBSTRATpro or

SUBSTRAT, 1 fine filter pad white (order no. 2616135 / 3 pcs.),

1 carbon filter pad black (order no. 2628130 / 3 pcs.). After-

wards rinse filter medi container under running water to remove

residues.



b



c



a



b



d



e



c



a

Putting into operation

There are 3 ways to prime the filter. 1) With the starter bulb (order

no. 4003540), 2) with the Universal Installation Kit 1 (see G

1, order

no. 4004300) or 3) by sucking the hose on the pressure side.

Connect the pressure side hose to the outlet elbow and the spray

bar while the filter fills with water. The pump can be switched on

when water has filled the filter, and for a short time while trapped

air is exhausted from the filter media a slight noise from the pump

will be heard (this is normal). Fit the plug into the end of the spray

bar after all the air bubbles have disappeared.

Important: When the filter media need cleaning or changing and the fil-

ter is taken away from the aquarium, please note the following points

Installation

C Fit the lid of the filter media container, close it by turning clockwise

and place into the filter canister. Put on the pump head and exam-

ine the o-ring for correct fitting. Close the clips.

D Place filter underneath aquarium – it must be below water level.

E/F Fit outlet pipe as per drawing A or B.

G Assemble suction pipe and strainer and attach to side of aquarium

with 2 suction cups and fit hose connections to filter: suction side

on bottom intake nozzle, pressure side on pump head. Fasten

hoses with clamping nut (drawing K).

1) The filter must have no water in it when reconnecting to the aquar-

ium.

2) The pressure hose to the spray bar must be drained of water and

the tap (if fitted) left open.

3) After connections are made the tap on the suction side can be

opened (it holds the syphon). Water will flow into the filter expelling

all air out of the spray bar, eliminating air locks and ensuring a

perfect prime.

Servicing and maintenance

H/I Pull out mains plug. Release locking piece on pump head and re-

move pump parts as per drawing. Lift out cooling channel insert

(I) with screwdriver. Clean all parts and then reassemble in the

reverse order.

Note: All hose connections must be checked at regular intervals for

correct fitting.

Attention: The impeller blades must rotate free on the impeller, and

the impeller must spin freely on the ceramic shaft, so that the pump

starts without trouble.

Français

Mercy beaucoup

pour l’achat de votre nouveau filtre extérieur EHEIM classic. Il offre d’ex-

cellentes performances avec une fiabilité et une efficacité maximales.

Consignes de sécurité

Usage intérieur exclusivement. Destiné à être utilisé uniquement en aqua-

riophilie.

Avant de plonger la main dans l’eau de l’aquarium, retirer les prises élec-

triques de tous les appareils installés dans l’eau. Avant d’ouvrir le filtre, le

débrancher entièrement du secteur.

La ligne de raccordement de l’appareil ne peut pas être remplacée. L’usage

de l’appareil est interdit lorsque le câble est endommagé ou coupé. Adres-

sez-vous à votre négociant spécialisé ou à votre service après-vente EHEIM.

Cet appareil n’est pas destiné à être utilisé par des personnes (enfants y com-

pris) aux capacités physiques, sensorielles ou intellectuelles limitées ou dé-

pourvues d’expérience ou de connaissance, à moins qu’elles ne se trouvent

sous la surveillance d’une personne responsable de la sécurité ou obéissent

à ses recommendations sur la manière d’utiliser l’appareil. Veillez surveiller

les enfants afin de pouvoir être certain qu’ils ne jouent pas avec l’appareil.

Remarque: avec ces appareils, des champs magnétiques peu-

vent provoquer des troubles ou des détériorations électroniques

et mécaniques. Ceci est également valable pour les stimulateurs car-

diaques. Les distances nécessaires de sécurité doivent être relevées dans

les manuels de ces appareils médicaux.

Attention: en cas de travaux de maintenance, risque de

coincement en raison de forces magnétiques élevées.

Pour votre propre sécurité, nous vous recommandons

de former un col de cygne avec le câble pour éviter que

l’eau s’écoulant éventuellement de long du câble ne

20 cm

Page is loading ...

Für Aquarien bis 250 l 250 l

For aquariums up to

Pour aquariums jusqu’à

Voor aquaria tot 55 Imp. gal. 66 U.S. gal.

För akvarier upp till

Per acquari fino a

Pumpenleistung 440 l/h 440 l/h

Pump output

Débit de la pompe

Pompcapaciteit 97 Imp. gal./h 116 U.S. gal./h

Pumpkapacitet

Potenza della pompa

Förderhöhe H max m 1,50 1,50

Delivery head m wat. col.

Hauteur de réf. m col. d’eau

Opvoerhoogte m / wk 4 ft./ 11 inches 4 ft./ 11 inches

Lyfthöjd m / vst

Prevalenza mt. acqua

Filtervolumen 3 l 3 l

Filter volume

Volume de la cuve

Filtervolume

Filtervolym

Volume filtro

Leistungsaufnahme W 8 8

Power consumption W

Consommation de courant W

Stroomverbruik W

Effekt W

Assorbimento W

Abmessungen ø 160 x 355 mm

Dimensions

Afmetingen ø 6.3 x 13.9 inches

Måttuppgifter

Dimensioni

Aufstellhöhe max. 180 cm

Installation height

Hauteur de mise en place

Opstelhoogte max. 5 ft./ 10 inches

Höjdavstånd

Altezza dell’installazione

230 V / 50 Hz 120 V / 60 Hz

240 V / 50 Hz 220 V / 60 Hz

2213

Page is loading ...

EHEIM 250 Owner's manual

This manual is also suitable for

EHEIM 250 Owner's manual

in other languages

Related papers

Other documents