2. OKI
  3. C9650HDN
C9650HDN

OKI C9650HDN, C 9650dn, C9650hnColorSignage, C9650n Installation guide

  • Hello! I am an AI chatbot trained to assist you with the OKI C9650HDN Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Transfer Belt
Installation Instructions
Caution! The fuser is very HOT after the
printer has been printing. For your
safety, let the printer cool down at
least 10 minutes before attempting
to replace the transfer belt.
To replace the belt unit:
1. Turn off the printer.
Note: If the hard disk drive is installed in
your printer, press the SHUTDOWN/
RESTART button for several seconds
before turning the printer off.
2. Open the top cover.
Caution! The fuser is very HOT after the
printer has been printing. Be
careful not to touch it!
3. Remove the four image drums/toner cartridge
units and place them on a flat surface.
4. Cover them with dark paper or plastic to
protect them from light.
5. Lift the transfer belt latches to release them.
© 2009 Oki Data Americas, Inc. 58396901
6. Grasp the blue handles and lift the transfer
belt out. Dispose of it in accordance with local
regulations.
Warning! Do not incinerate the used
transfer belt. It may explode
and cause a fire hazard.
7. Unpack the new transfer belt, grasp the blue
handles and lower the left side of the belt into
the printer, fitting the pins into the guides at
the front and back, then lower the right side.
8. Push down on the belt latches to lock the new
belt in place.
9. Put the image drum/toner cartridge units back
into the printer.
10. Close the top cover.
11. Turn the printer on.
Oki Data Americas, Inc., 2000 Bishops Gate Blvd., Mt. Laurel, NJ 08054 www.okiprintingsolutions.com
/