Rolls PS 16 User manual

Rolls
Brand
Rolls
Model
PS 16
Type
User manual

This manual is also suitable for

Rolls PS 16 is a personal monitor power center that provides power for up to ten PM50s, PM55, and PM351 units. It also distributes the monitor signal to the aforementioned units, eliminating the need for multiple wall-warts and adapter cables. The PS16 has unbalanced 1/4" and transformer-balanced XLR inputs, and it comes with a 12VAC power adapter. The power and monitor signal are carried from each PS16 output using an ordinary 1/4" stereo cable to the monitor input of the PM50s, 55, and 351. Using stereo “Y” adapters, up to ten of the Personal Monitor Amplifiers may be daisy-chained.

Rolls PS 16 is a personal monitor power center that provides power for up to ten PM50s, PM55, and PM351 units. It also distributes the monitor signal to the aforementioned units, eliminating the need for multiple wall-warts and adapter cables. The PS16 has unbalanced 1/4" and transformer-balanced XLR inputs, and it comes with a 12VAC power adapter. The power and monitor signal are carried from each PS16 output using an ordinary 1/4" stereo cable to the monitor input of the PM50s, 55, and 351. Using stereo “Y” adapters, up to ten of the Personal Monitor Amplifiers may be daisy-chained.

Owners Manual
Rolls Corporation
Salt Lake City, UT
12/10
PS16
POWER CENTER
Personal Monitor
Power Supply
Signal Distribution
PS16
POWER CENTER
The PS16 supplies the DC power and distributes
the Monitor signal to up to ten of the PM50s, the
PM55, and the PM351 units. This
dramatically increases efficiency and eliminates
the need for multiple wall-warts and adapter
cables.
• Supplies power for up to ten PM50s,
PM55, and PM351 units.
• Directly supplies a monitor signal to the
above listed units.
• Unbalanced 1/4" and TRANS
FORMER-balanced XLR inputs.
power
status
PS16
+
-
LINE INPUTS
unbal
balanced
PERSONAL MONITOR
POWER CENTER
OUT 1 OUT 2 OUT 3 OUT 4
WARNING:
THIS UNIT MAY BE DAMAGED IF THE LIGHT IS OFF
WHEN POWER IS APPLIED - IMMEDIATELY UNPLUG
ALL OUTPUTS. USE TIP-RING-SLEEVE PLUGS ONLY.
12VAC
www.rolls.com
READ THIS MANUAL FOR IMPORTANT OPERA-
TION INSTRUCTION. TIP-RING-SLEEVE PLUGS
ARE
REQUIRED FOR THE OUTPUTS OF THIS
UNIT.
SPECIFICATIONS
Input Power: VAC
Output Power: 12 VDC on the Ring terminal of each OUT jack.
Size: 3.125" x 3.125" x 1.25"
Weight: 1 lb (.45 Kg)
1
ROLLS CORPORATION
5968 S 350 West
MURRAY UT 84107
1
AHCS.61SP
22 MAY 2002
Document Number:
Date:
Rev:
Sheet of
PS16 PM POWER CENTER
Ba
IN 9-15 VAC/VDC
HIGH OUT
PM SERIES OUTS
LOW OUT
J1
PHONE 1/4
C7
1U
J2
PHONE 1/4
J3
PHONE 1/4
J4
PHONE 1/4
2
3
1
J10
JAPDC
D5
LDRR
R1
4.7K
D1
1N4001
D2
1N4001
D3
1N4001
D4
1N4001
C17
2200UF 16V
J2
PHONE 1/4
1
2
3
J11
XLR JACK M
T1
XFMR AUDIO
I
1
G
2
O
3
U1
7812
SCHEMATIC
INTRODUCTION
Thank you for your purchase of the PS16 Personal Monitor Power Center.
The PS16 supplies the DC power and distributes the Monitor signal to up
to ten of the PM50s, the PM55, and the PM351 units. This dramati-
cally increases efficiency and eliminates the need for multiple wall-warts
and adapter cables.
The power AND monitor signal are carried from each PS16 output using
an ordinary 1/4" stereo cable to the Monitor input of the PM50s, 55, and
351. Using stereo “Y” adapters, up to ten of the Personal Monitor Amplifi-
ers may be daisy-chained.
NOTE: Very old PM50s and PM50sob units may not
work with a PS16.
Any PM50s or PM50sob WITHOUT a
ground lift jumper and mono/stereo jumper
FEATURES
- Supplies power for up to ten PM50s, PM55, and PM351 units.
- Directly supplies a monitor signal to four of the above units, indirectly (by
using stereo “Y” adapters) will provide signal for up to ten units.
- Unbalanced 1/4" and TRANSFORMER-balanced XLR inputs.
DESCRIPTION
LINE INPUTS
UNBALANCED: 1/4' Tip-Sleeve jack. Connects to a mixer's unbalanced
Monitor or Auxiliary Send.
BALANCED: Transformer isolated
female XLR jack.Connects to a mixer's
balanced Monitor or Auxiliary Send.
12VAC: Connects to the included Rolls
PS12 power adapter.
OUT 1 - 4: 1/4" Tip-Ring-Sleeve jacks.
The Tip of the connector contains the
audio signal, the Ring has the 12 volts
DC required to operate the Personal
Monitor devices, and the Sleeve con-
nects to ground.
power
status
PS16
+
-
LINE INPUTS
unbal
balanced
PERSONAL MONITOR
POWER CENTER
OUT 1 OUT 2 OUT 3 OUT 4
WARNING:
THIS UNIT MAY BE DAMAGED IF THE LIGHT IS OFF
WHEN POWER IS APPLIED - IMMEDIATELY UNPLUG
ALL OUTPUTS. USE TIP-RING-SLEEVE PLUGS ONLY.
12VAC
www.rolls.com
CONNECTION / OPERATION
• Connect the Send of the mixer to the appropriate Input of the PS16
(balanced or unbalanced).
• Connect the PS12 adapter to the VAC input of the PS16. The Power/
Status LED should light. If not, immediately unplug the power as this
indicates a short from the Ring of an Output jack to ground.
• Connect the TIP-RING-SLEEVE STEREO cables from the PS16
Outputs to the PM series Monitor Inputs. Refer to the Personal Monitor
unit owners manual for proper operation of that unit.
will not work with a PS16.
  • Page 1 1
  • Page 2 2

Rolls PS 16 User manual

Rolls
Brand
Rolls
Model
PS 16
Type
User manual
This manual is also suitable for

Rolls PS 16 is a personal monitor power center that provides power for up to ten PM50s, PM55, and PM351 units. It also distributes the monitor signal to the aforementioned units, eliminating the need for multiple wall-warts and adapter cables. The PS16 has unbalanced 1/4" and transformer-balanced XLR inputs, and it comes with a 12VAC power adapter. The power and monitor signal are carried from each PS16 output using an ordinary 1/4" stereo cable to the monitor input of the PM50s, 55, and 351. Using stereo “Y” adapters, up to ten of the Personal Monitor Amplifiers may be daisy-chained.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents