Viking Range STKRVRFSS Installation guide

Viking Range
Brand
Viking Range
Model
STKRVRFSS
Type
Installation guide

This manual is also suitable for

Installation
GUIDE
3 SERIES
French Door Refrigeration (RVRF336 Series)
Side Trim and Top Grille Kit
GKRVRF1SS
STKRVRFSS
2
Parts included in
GKRVRFSS Top Grille Kit
Parts included in
STKVRFSS Top Grille Kit
Screws (4)
Right
Spacer
Left
Spacer
Grille
Washers (2)
For installing side spacers
Left Shim
Trim
Right Shim
Trim
Left Side
Trim
Right Side
Trim
Installation - GKRVRFSS (Top Grille without side trim)
1
step
B
2
Attach spacers, included in the kit, to the
grille assembly with four screws. DO NOT
install spacers if installing the side trim.
Align and position grille on top of unit
so that the face of the grille and the face
of the door are  ush.
These
surfaces
must be
flush
Grille
Door
Side View
3
Remove plastic caps from the top hinges
by removing (3) 1/4” hex head screws. Save
these screws to replace plastic caps.
Use the two inner hole locations to
properly align the grille.
4
Place plastic caps back on top of hinges
and located exisiting holes. Insert screws
making sure the grille is centered.
Use washer when replacing screw in
rear hole of plastic cap. Tighten all
hex screws
5
6
Alcohol Swab
Alcohol Swab
Alcohol Swabs (2)
3
Side trim can be installed after attaching the grille assembly without the side spacers.
Installation - GKRVRFSS and STKVRFSS (Top Grille and Side Trim)
2
71-7/8”
(182.6 cm)
3
2
2
1
4
2
2
1
complete
Raise the unit up until the measurement from the
oor to the top of the grille assembly is 71-7/8
inches.
Shim trim has adhesive backing on both sides. Remove adhesive
backing on refrigerator side only. Fit the shim trim to the front of
the unit  rst. With center hinge, the shim trim will have a cutout.
Use the cutout to locate the height of the shim trim.
Remove adhesive backing for the side trim. Locate
the top of the side trim with the top of the grille
assembly. Press the side trim into the refrigerator
cabinet at the center location.
Speci cations
Freestanding Refrigerators
Description RVRF336*
Overall height with grille 71-7/8” (182.6 cm)
Cutout height with grille 72” (182.9 cm)
Before installing the side
trim, install the grille
assembly without the side
spacers. Use alcohol swabs
to clean areas of refrigerator
cabinet and inside of side
trim to ensure adhesive
backing adheres to cabinet
and side trim.
1
step
Viking Range, LLC
111 Front Street
Greenwood, Mississippi 38930
(662) 455-1200
For product information, call 1-888-845-4641
or visit our web site at vikingrange.com in the US or brigade.ca in Canada
057682-000B EN (091217)
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Viking Range STKRVRFSS Installation guide

Viking Range
Brand
Viking Range
Model
STKRVRFSS
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents