F AB GLASS
AND MIRROR
Fab Glass Teardrop Side Table
Installation Manual
www.fabglassandmirror.com Call: +1 888-474-2221 Fax: (614)-334-4919
Office Timing: 8:30 - 18:00 EST [email protected]
Thank you for your purchase! It is our desire to make your entire experience from
purchase to installation as easy as possible. We ask that you read each step of this
installation manual thoroughly to ensure proper installation of your new Tear Drop
Glass Table. Our installation techniques are very important. Installing your Table in any
manner other than the steps outlined in this manual may lead to structural failure of
your Table.
It is your responsibility to see that your Tear Drop Glass Table is properly assembled,
installed, and cared for. Failure to follow instructions in this manual could result in
serious injury. Use this product with Glass cautions.
Hardware Included with this order
CAUTION
Nut
(Qty - 1)
Tighten Key
(Qty - 1)
Mid Rod
(Qty - 1)
Spring
(Qty - 1)
1
2
3
By using your cutting tool,
carefully open the
package and remove
the table and hardware.
Set the Table Top
down on a flat surface,
and HAND TIGHTEN
the screw into the
mounting bracket
in the hole closest
to the corner of the
Table Top.
Screw the included rod
into the other hole in
the mounting bracket
and HAND TIGHTEN it.
1
Page
www.fabglassandmirror.com
+ 1 888-474-2221
Fragile Handle with care
FRAGILE
GLASS
F AB GLASS
AND MIRROR
www.fabglassandmirror.com
+ 1 888-474-2221
Fragile Handle with care
FRAGILE
GLASS
F AB GLASS
AND MIRROR
Glass Table Top
Mid Rod
4
5
Slide the base of the
table over the rod as
shown in the illustration.
Install the table base
attachment screw on
the rod tip and tighten
with the included
tighten key.
2
Page
Congratulations!
You have successfully assembled
your Teardrop Glass Table.
Table Base
Tighten Key
Nut
/
