2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. Peerless Industries
  6. ACC 550

Peerless Industries ACC 550, Washer/Dryer ACC 550 User manual

  • Hello! I am an AI chatbot trained to assist you with the Peerless Industries ACC 550 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
ISSUED: 04-24-00 SHEET #: 142-9006-5 03-03-03
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
1 of 3
Some parts may appear slightly different than illustrated.
Installation and Assembly - Unistrut adapter for truss ceiling
Model: ACC 550
IMPORTANT! Read entire instruction sheet before you start installation and assembly.
Before you start make sure all parts listed are included with your product.
PART # QTY. DESCRIPTION
A 580-1042 1 mounting body
B 142-1001 1 alignment plate
C 142-1002 1 attachment plate
D 5S1-M10-A20 2 M10 x 20mm socket head screw
E 520-9560 1 10-32 x 1/2" phillips screw
Parts List
Attach mounting body (A) to alignment plate (B)
using two M10 socket head screws (D) and
attachment plate (C).
E
C
D
A
B
D
A
B
C
D
This product must be
installed by a qualified,
professional installer.
R
MAXIMUM LOAD CAPACITY:
250 lb (114 kg)
ISSUED: 04-24-00 SHEET #: 142-9006-5 03-03-03
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
2 of 3
unistrut
unistrut
adapter
assembly
Slide unistrut adapter assembly onto
unistrut. Unistrut will slide in between
alignment plate (B) and attachment plate
(C).
unistrut
D
D
A
unistrut
E
flush
mount
tube
unistrut
adapter
assembly
C
B
unistrut
Once unistrut adapter assembly is in desired position, tighten M10 socket head screws (D). When attaching the
mounting body (A) to flush mount tube or extension column. Tighten at least four complete turns ending with one of
the small threaded holes aligned with slot in the end of flush mount tube. Insert and tighten one security screw (E)
shown below right.
ISSUED: 04-24-00 SHEET #: 142-9006-5 03-03-03
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
3 of 3
If unistrut is closed on both
ends place attachment plate (C)
inside unistrut. Attach alignment
plate (B) and mounting body (A)
to attachment plate (C) using two
M10 socket head screws (D).
C
C
unistrut
unistrut
C
A
D
D
B
© 2003 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
/