Intermec SR60 Operating instructions

Brand: Intermec

Model: SR60

Type: Operating instructions

Intermec SR60 is a versatile hands-free barcode scanner designed to enhance your productivity and streamline your workflow. With its AutoSense mode, the SR60 automatically detects and scans barcodes without manual triggering, providing a seamless and efficient scanning experience. The adjustable stand allows you to customize the height for optimal scanning angles, while the easy-to-use design enables quick installation and removal of the scanner.

Intermec SR60 is a versatile hands-free barcode scanner designed to enhance your productivity and streamline your workflow. With its AutoSense mode, the SR60 automatically detects and scans barcodes without manual triggering, providing a seamless and efficient scanning experience. The adjustable stand allows you to customize the height for optimal scanning angles, while the easy-to-use design enables quick installation and removal of the scanner.

Learning About the Hands Free Stand

The SR60 Hands Free Stand allows you to use AutoSense mode for the

SR60 scanner. When enabled, AutoSense detects when a bar code is

placed within range and automatically scans without the need to

manually trigger the scanner.

These instructions provide directions for adjusting the stand height,

installing and removing the scanner, and configuring the scanner.

Adjusting the Stand Height

To adjust the stand height

1 Pull and hold the retaining knob while sliding the top assembly to

the desired height.

2 Release the retaining knob and readjust the height so that the

retaining pins latch onto the retaining holes.

SR60 Hands Free Stand Instructions

Retaining knob

Scanner cradle

Retaining

pins

Installing and Removing the Scanner

To install the scanner

1 Place the top end of the scan window onto the stand.

2 Pivot the scanner by the handle into the cradle until the latch

engages the indent on the cap.

3 Verify that the trigger is pushed down by visually checking that the

bump on the stand cradle pushes on the trigger.

4 Once the trigger has been pushed down, the AutoSense mode is

ready to use. See “Configuring the Scanner” on the next page to

enable AutoSense mode.

To remove the scanner

1 Grasp the scanner at the handle near the latch.

2 Pull up and forward to release the scanner from the latch.

Scanner

cradle

Hands free

stand

Latch indent

Latch

Scanner

cradle

Latch

Hands free

stand

Lift the scanner

handle to remove

Configuring the Scanner

You can enable Autosense mode when you use the scanner with the

stand.

To set AutoSense mode On or Off

1 Scan the SET bar code.

2 Scan the bar code for the option you want to configure.

3 Scan the END bar code.

SET---------------------------

Enable ---------

Disable ---------

END--------------------------

SR60 Hands Free Stand Instructions

*943-088-001*

P/N 943-088-001

6001 36th Avenue West

Everett, Washington 98203

U.S.A.

tel 425.348.2600

fax 425.355.9551

www.intermec.com

©

2005 Intermec Technologies

Corporation. All rights reserved.

1
2
3
4

Intermec SR60 Operating instructions

Brand: Intermec

Model: SR60

Type: Operating instructions

Intermec SR60 is a versatile hands-free barcode scanner designed to enhance your productivity and streamline your workflow. With its AutoSense mode, the SR60 automatically detects and scans barcodes without manual triggering, providing a seamless and efficient scanning experience. The adjustable stand allows you to customize the height for optimal scanning angles, while the easy-to-use design enables quick installation and removal of the scanner.

Related papers

Other documents