Learning About the Hands Free Stand
The SR60 Hands Free Stand allows you to use AutoSense mode for the
SR60 scanner. When enabled, AutoSense detects when a bar code is
placed within range and automatically scans without the need to
manually trigger the scanner.
These instructions provide directions for adjusting the stand height,
installing and removing the scanner, and configuring the scanner.
Adjusting the Stand Height
To adjust the stand height
1 Pull and hold the retaining knob while sliding the top assembly to
the desired height.
2 Release the retaining knob and readjust the height so that the
retaining pins latch onto the retaining holes.
SR60 Hands Free Stand Instructions
Retaining knob
Scanner cradle
Retaining
pins
Installing and Removing the Scanner
To install the scanner
1 Place the top end of the scan window onto the stand.
2 Pivot the scanner by the handle into the cradle until the latch
engages the indent on the cap.
3 Verify that the trigger is pushed down by visually checking that the
bump on the stand cradle pushes on the trigger.
4 Once the trigger has been pushed down, the AutoSense mode is
ready to use. See “Configuring the Scanner” on the next page to
enable AutoSense mode.
To remove the scanner
1 Grasp the scanner at the handle near the latch.
2 Pull up and forward to release the scanner from the latch.
Scanner
cradle
Hands free
stand
Latch indent
Latch
Scanner
cradle
Latch
Hands free
stand
Lift the scanner
handle to remove
Configuring the Scanner
You can enable Autosense mode when you use the scanner with the
stand.
To set AutoSense mode On or Off
1 Scan the SET bar code.
2 Scan the bar code for the option you want to configure.
3 Scan the END bar code.
SET---------------------------
Enable ---------
Disable ---------
END--------------------------
SR60 Hands Free Stand Instructions
*943-088-001*
P/N 943-088-001
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
©
2005 Intermec Technologies
Corporation. All rights reserved.
/
