Silvercrest SFM 4 A1 Operating Instructions Manual

Wireless Optical MOuse sFM 4 a1

Optische FunkMaus

Bedienungsanleitung

IAN 279402

Wireless Optical MOuse

Operating instructions

Optinė belaidė pelė

Naudojimo instrukcija

Optyczna Myszka

bezprzeWOdOWa

Instrukcja obsługi

GB / IE Operating instructions Page 1

PL Instrukcja obsługi Strona 25

LT Naudojimo instrukcija Puslapis 49

DE / AT / CH Bedienungsanleitung Seite 73

Before reading, unfold the page containing the illustrations and

familiarise yourself with all functions of the device.

Przed przeczytaniem proszę rozłożyć stronę z ilustracjami, a na-

stępnie proszę zapoznać się z wszystkimi funkcjami urządzenia.

Prieš skaitydami atsiverskite lapą su paveikslėliais ir susipažinkite

su visomis prietaiso funkcijomis.

Klappen Sie vor dem Lesen die Seite mit den Abbildungen aus

und machen Sie sich anschließend mit allen Funktionen des

Gerätes vertraut.

SFM 4 A1 – Software CD

�黑印刷

Wireless Optical MOuse sFM 4 a1

Optische FunkMaus

Bedienungsanleitung

IAN 279402

Wireless Optical MOuse

Operating instructions

Optinė belaidė pelė

Naudojimo instrukcija

Optyczna Myszka

bezprzeWOdOWa

Instrukcja obsługi

CV_279402_SFM4A1_LB3.indd 2 20.06.16 15:56

IAN 279402

Kompernass Handels GmbH

BURGSTRASSE 21

44867 BOCHUM

DEUTSCHLAND / GERMANY

www.kompernass.com

Last Information Update · Stan informacji

Informacijos data · Stand der Informationen:

06 / 2016 · Ident.-No.: SFM4A1-062016-2

3

GB

│

1 ■

SFM 4 A1

Contents

Introduction ..........2

Copyright .............2

Limitation on liability .....2

Intended use ...........3

Warnings used .........4

Notes on trademarks ....5

Safety ...............5

Basic safety guidelines ...5

Controls and package

contents .............9

Initial operation .......9

Check package contents .9

Disposal of packaging

materials .............10

Inserting/replacing the

batteries .............11

Connecting the nano-USB

receiver ..............11

Power-saving mode .....12

Changing operating

modes ...............12

Installing the software ...13

Conﬁguration of the mouse

buttons ..............15

Troubleshooting .... 17

Cleaning ........... 18

Storage when not

in use ............. 18

Disposal ........... 19

Disposal of the device ...19

Disposal of batteries ....19

Appendix .......... 20

Technical data .........20

Notes on the EU Declara-

tion of Conformity ......21

Kompernass Handels

GmbH warranty .......21

Service ..............24

Importer .............24

■ 2

│

GB

SFM 4 A1

Introduction

Congratulations on the purchase of your new device.

You have selected a high-quality product. The operating

instructions are part of this product. They contain impor-

tant information on safety, usage and disposal. Before

using the product, familiarise yourself with all handling

and safety guidelines. Use the product only as described

and for the range of applications speciﬁed. Keep these

operating instructions in a safe place. Please also pass

these operating instructions on to any future owner(s).

Copyright

This documentation is subject to copyright protection.

Any reproduction, or any reprint even in the form of

excerpts, as well as the rendition of ﬁgures even in modi-

ﬁed form, is only permitted with the manufacturer’s written

consent.

Limitation on liability

All the technical information, data and instructions regard-

ing installation, connection and operation contained in

these operating instructions corresponds to the latest infor-

mation available to us at the time of printing and takes

our previous experience and know-how into account.

GB

│

3 ■

SFM 4 A1

No claims may be derived from the speciﬁcations, ﬁgures

and descriptions in these operating instructions. The manu-

facturer assumes no responsibility for damage caused

by failure to observe these instructions, improper use,

incompetent repairs, making unauthorised modiﬁcations

or for using unapproved replacement parts.

Intended use

This wireless mouse is an information technology device

designed as an input device for a computer. The device

must not be used outside of closed rooms. This device

is not intended for use in companies or for other com-

mercial uses (e.g. oﬃce productivity applications). Use

the device only in the home for private purposes. It is

not intended for any other use. Claims of any kind for

damage arising as a result of incorrect use will not be

accepted. The risk shall be borne solely by the user.

■ 4

│

GB

SFM 4 A1

Warnings used

The following warnings are used in these operating

instructions:

DANGER

A warning at this hazard level indicates

an imminently hazardous situation.

Failure to avoid this hazardous situation could

result in severe injuries or even death.

► Follow the instructions in this warning notice to

avoid the risk of serious injuries or death.

CAUTION

A warning at this hazard level indicates

potential material damage.

Failure to avoid this situation could result in material

damage.

► Follow the instructions in this warning to prevent

material damage.

NOTE

► A note indicates additional information that eases

device handling.

GB

│

5 ■

SFM 4 A1

Notes on trademarks

- USB

®

is a registered trademark of USB Implementers

Forum, Inc.

- Microsoft

®

, Windows

®

and other Microsoft product

names are registered trademarks of the Microsoft

Corporation.

- Intel

®

and Pentium

®

are registered trademarks of the

Intel Corporation.

- AMD

®

and AMD

®

Athlon™ are registered trademarks

of Advanced Micro Devices, Inc.

All other names and products may be trademarks or

registered trademarks of their respective owners.

Safety

In this section, you will receive important safety advice

relating to device handling. Improper use may result in

personal injury and material damage.

Basic safety guidelines

To ensure safe handling of the device, follow the safety

guidelines set out below

■

DANGER! LED radiation!

Avoid damage to eyes. Do not stare into the LED

beam. Do not look directly at the LED beam using

optical instruments.

■ 6

│

GB

SFM 4 A1

■ This appliance may be used by children aged 8

over and by persons with reduced physical, sensory

or mental capabilities or lack of experience and

knowledge, provided that they are under supervision

or have been told how to use of the appliance safely

and are aware of the potential risks. Children must

not play with the appliance. Cleaning and user main-

tenance tasks must not be carried out by children

unless they are supervised.

■ Prior to use, check the device for visible external

damage. Do not operate a device that has been

damaged or dropped.

■ Always place the device on a stable and level surface.

It can be damaged if dropped.

■ Do not expose the device to direct sunlight or high

temperatures. Otherwise it may overheat and be

irreparably damaged.

■ Do not place the product near heat sources such

as radiators or other heat-generating devices.

■ Never attempt to open the device.

■ Do not make any unauthorised modiﬁcations or

alterations to the device.

■ Do not expose the device to spray or dripping water

and do not place liquid-ﬁlled objects, such as vases

or open drink containers, on or near the device.

GB

│

7 ■

SFM 4 A1

■ DANGER! Packaging materials such as plastic

ﬁlm must not be used as playthings.

Risk of suﬀocation!

DANGER

Mishandling the batteries can cause ﬁres,

explosions, leakages or other hazards!

► Do not throw the batteries into a ﬁre and do not

subject them to high temperatures.

► Do not open, deform or short-circuit batteries,

since this can lead to chemical leakage.

► Do not attempt to recharge batteries. Do not

charge batteries unless they are explicitly labelled

as "rechargeable". There is a risk of explosion!

► Check the condition of the batteries at regular

intervals. Leaking chemicals can cause permanent

damage to the device. Take particular care when

handling damaged or leaking batteries. Risk of

chemical burns! Wear protective gloves.

► Chemicals which leak from a battery can cause

skin irritation. In event of contact with the skin, rinse

with copious amounts of water. If the chemicals come

into contact with your eyes, rinse thoroughly with

water, do not rub and consult a doctor immediately.

■ 8

│

GB

SFM 4 A1

DANGER

► Keep batteries out of the reach of children.

Children can put batteries into their mouth and

swallow them. If a battery has been swallowed,

seek medical assistance immediately as this can

lead to severe internal burns (or even death) within

two hours.

► Do not mix diﬀerent types of batteries.

► Always insert the batteries the right way round

(observe correct polarity) otherwise there is a

danger that they could explode.

► If you do not intend to use the device for a long

time, remove the batteries.

GB

│

9 ■

SFM 4 A1

Controls and package contents

1 Left mouse button

2 Right mouse button

3 Scroll wheel

4 DPI button

5 Back button

6 Forward button

7 Optical sensor

8 Battery compartment

9 Storage compartment for the nano-USB receiver

0 Nano-USB receiver

q Software CD

w 2 x 1.5 V batteries

e Operating instructions

Initial operation

Check package contents

The following components are included in delivery:

● Wireless mouse SFM 4 A1

● Nano-USB receiver 0

● Software CD q

● 2 x 1.5 V batteries w

● These operating instructions e

■ 10

│

GB

SFM 4 A1

NOTE

► Check the consignment for completeness and for

signs of visible damage.

► If the consignment is incomplete or damaged due

to defective packaging or carriage, contact the

Service hotline (see the chapter Service).

Remove all parts of the device from the packaging and

remove all packaging materials.

Disposal of packaging materials

The packaging protects the device from damage during

shipment. The packaging materials have been selected

for their environmental friendliness and ease of disposal

and are therefore recyclable.

Returning the packaging to the materials

cycle conserves raw materials and reduces

the amount of waste that is generated.

Dispose of packaging materials which are no longer

needed in accordance with applicable local regulations.

GB

│

11 ■

SFM 4 A1

Inserting/replacing the batteries

♦ Open the battery compartment 8 on the underside

of the wireless mouse.

♦ Insert 2 x 1.5 V AA batteries into the battery com-

partment 8 (observe correct polarity). First place

one battery in the lower compartment and then the

second battery in the higher compartment. Ensure

that the plastic strip is positioned under the batteries,

this will make future battery exchanges easier.

♦ Close the battery compartment 8.

CAUTION

► Always use batteries from the same manufacturer

and of the same type. Always replace both batteries

at the same time.

Connecting the nano-USB receiver

♦ Remove any other mouse that is connected to your

computer and then restart the computer.

♦ Remove the nano-USB receiver 0 from the storage

compartment 9 on the bottom of the wireless

mouse.

♦ Connect the nano-USB receiver 0 to a free USB-port

on your computer while it is running.

■ 12

│

GB

SFM 4 A1

The operating system recognises the new hardware

and automatically installs the necessary drivers. After

the installation of the driver, the wireless mouse is ready

for operation and can be used.

Power-saving mode

The wireless mouse is equipped with a power-saving mode.

■ If you switch the computer oﬀ, the wireless mouse

automatically switches oﬀ after around 8 minutes

in order to save power.

■ If you disconnect the nano-USB receiver 0 from the

computer, the wireless mouse automatically switches

oﬀ after around 8 minutes in order to save power.

■ If you do not click, scroll or move the wireless mouse,

it turns oﬀ after about 8 minutes. As soon as you

press any button on the wireless mouse or use the

scroll wheel, the wireless mouse switches back on.

Changing operating modes

You can use the DPI button 4 to switch the optical sam-

pling between the resolutions 1000 dpi, 1500 dpi and

2000 dpi. The higher the resolution, the more accurate

the wireless mouse’s sampling.

GB

│

13 ■

SFM 4 A1

Installing the software

To be able to use the full functionality of the mouse, you

must install the supplied software.

NOTE

► The following illustrations and descriptions relate

to the operating system Microsoft

®

Windows

®

7.

The screen display may diﬀer for other operating

systems.

♦ Insert the supplied software CD q in the CD-ROM

drive of your computer.

The installation process should start automatically.

♦ If this is not the case, start the “setup.exe” ﬁle on the

CD-ROM manually by double-clicking it.

The installation starts and the installation wizard is

displayed.

■ 14

│

GB

SFM 4 A1

The start window of the installation wizard will be displayed.

♦ Click on the “Next >” button.

♦ In the next step, you can choose the destination

folder for the installation by using the “Browse”

button or selecting the suggested destination.

♦ Move on to the next step by clicking on the

“Next >” button.

GB

│

15 ■

SFM 4 A1

♦ To ﬁnish the installation, click the “Finish” button.

The computer will be restarted.

Conﬁguration of the mouse buttons

You can use the software to customise the mouse

functions according to your personal preferences.

♦ Double-click on this icon

in the system tray

(bottom left of your screen, next to the clock) or click

on the icon with the right mouse button and select

“Mouse properties” from the context menu.

■ 16

│

GB

SFM 4 A1

The conﬁguration menu for the mouse appears.

♦ Select the tab “Conﬁguration of mouse button”.

Here you can set a function for each of the ﬁve

mouse buttons.

♦ Click on the drop-down menu for the corresponding

mouse button and select a function from the menu.

♦ To apply the changes, click on the “Apply” button

(the window remains open) or on “OK” (the window

closes).

Page is loading ...

Silvercrest SFM 4 A1 Operating Instructions Manual

Silvercrest SFM 4 A1 Operating Instructions Manual

in other languages

Related papers

Other documents