MAAX 106460-000-001 Arno 7242 Installation guide

Type
Installation guide

This manual is also suitable for

ARNO 6040
ARNO 7242
Part Number: 8TEMPARNO
CENTERLINE
Quadrant 1
Quadrant 4
Quadrant 2
Quadrant 3
CENTERLINE
ENILRETNEC
19 3/8”
20”
28 1/2”
35”
Cut Out Template for Installation*
The following procedure is required for correct installation of the
Aquatic bath tub. This cut out represents one quarter of the unit.
Step 1: Draw a centerline horizontally and vertically on a 1”
(25mm) thick plywood deck.
Step 2: Place template in the upper left hand quadrant,
noted as quadrant 1 on the diagram to the right. Trace
template to outline quadrant 1.
Step 3: Take the paper cutout and flip over. Make sure
to match the dotted centerline on the paper with the
centerline on the plywood. Trace again to outline quadrant 2.
Step 4: Repeat step 3 until the other remaining quadrants
of the unit have been traced.
* The dimensions needed for site preparation and structure building should be
measured from the bath tub. Aquatic assumes no responsibility for incorrect installation.
Model Names
ARNO 6040 – ARNO 7242
  • Page 1 1

MAAX 106460-000-001 Arno 7242 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI