2. Computers & electronics
  3. Networking
  4. Network media converters
  5. ZyXEL
  6. PMG1005-T20B

ZyXEL PMG1005-T20B Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the ZyXEL PMG1005-T20B Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1/2 Copyright © 2018 Zyxel Communications Corp. All Rights Reserved
2
3
2
3
1
LAN
POWER
4
PON
Connect the power cable and press
the power button.
Make sure the LEDs are on and
check the status.
Connect a computer using an
Ethernet cable.
Connect the fiber optic cable to
the PON port.
Warning! To avoid possible eye
injury, do NOT look into an
operating fiber-optic module's
connector.
Quick Start Guide
1
INTERNET
Red
Green
Green
Off
Off
Off
Off
(Loss of Signal)
On: Power on and system ready
Off: Power off
On: Successful GPON fiber link
Blinking: Synching with OLT (fiber terminal)
Off: Power off
On: Not receiving an optical signal
Blinking: Receiving a weak optical signal
Off: Receiving a normal optical signal
Blinking: Transmitting/Receiving data on the
Ethernet link
Green
On: Successful Ethernet link
Off: Ethernet link down
PMG1005-T20B
GPON SFU with 1-port GbE LAN
Hardware Connections
POWER
PON
LOS
LAN
2/2
Copyright © 2018 Zyxel Communications Corp. All Rights
Reserved
S
ee the User's Guide at www.zyxel.com for more information, including customer support and safety warnings.
EU Importer: Zyxel Communications A/S | Gladsaxevej 378, 2. th. 2860 Søborg, Denmark | http://www.zyxel.dk
US Importer: Zyxel Communications, Inc | 1130 North Miller Street Anaheim, CA 92806-2001 | http://www.us.zyxel.com
None of the LEDs turn on
- Make sure that you have the correct power cord connected and plugged into an appropriate power
source.
The PON LED is blinking
- The fiber link is synchronizing. Please wait.
The PON LED is off
- The fiber link is down. Restart the Device.
The LOS LED is blinking
- The Device is receiving a weak optical signal. Reposition the Device.
The LOS LED is red
- The Device is not receiving an optical signal. Reconnect the fiber optic cable to the PON port.
The LAN LED is off
- The Ethernet connection is down. Reconnect the Ethernet cable to the LAN port.
If problems persist, please contact your vendor or customer support.
54 mm
Troubleshooting
Wall Mounting
GPON SN: XXXXXXXXXXXXXXX X
Serial Number: SYY41 W W XXXXX X
M A C Address: XXXXXXXXXXX X
Model Number: PMG1005-T20B
Power Consumption: 2.638Watt max.
Power Rating: 12V 0.5A
/