2. Home
  3. Lighting
  4. Flashlights
  5. Luxpro
  6. LP1100V2

Luxpro LP1100V2 User manual

  • Hello, I'm your chat assistant, and I've reviewed the user manual for the Luxpro LP1100V2 flashlight. This document provides instructions for operating the flashlight, including how to turn it on/off, cycle through modes, and replace the batteries. The flashlight features multiple modes (High, Low, Strobe), a waterproof rating, and is constructed with aircraft-grade aluminum. I'm ready to answer any questions you may have about the flashlight based on the manual.
  • How do I turn the flashlight on and off?
    How do I cycle through the different light modes?
    What type of batteries does the flashlight use?
    What does the light automatically reset to when off for a while?
USER MANUAL
Operation Instructions
Constructed with aircraft-grade aluminum
Long range LPE optics
Patented TackGrip molded rubber grip
Ergonomic side button
IPX6 waterproof rating
Batteries included (2 D)
Features
14725 S Porter Rockwell Blvd Ste C
Bluffdale, UT 84065
luxpro.com
866.553.8886
Battery Replacement
The LP1100V2 has a Limited Lifetime Warranty Against Manufacturer’s
Defects from time of purchase.
For warranty claims please contact us by calling 801-553-8886 or
sending an email to info@simpleproducts.com
Product Warranty
High-Output Universal
Large Flashlight
LP1100V2
2 D
Batteries
On/O: Press and release the button on the side of the light to
turn on and o.
Cycle Modes: First turn the light on by pressing down the button
on the side of the light completely and releasing. Half-press the
button to cycle through modes (High/Low/Strobe). Turning the
ashlight on and o, quickly and repeatedly will also cycle the
light through the three modes.
The light will automatically reset to High mode when o for
longer than 3 - 5 seconds.
The LP1100V2 uses 2 D batteries.
To replace the batteries, turn the tail cap counterclockwise to
remove it. Tip the light downward to slide out the old batteries.
Insert new batteries (+) side facing down. For best results, we
recommend using brand new alkaline batteries that are the same
voltage and brand.
Re-attach the tail cap by pressing down lightly and turning it
clockwise until tight.
If you know it will be a while between uses, we suggest removing
the batteries from the ashlight and storing it in a dry, protected
place.
Strobe
High
ANSI/PLATO FL1 STANDARD
360 lm
360 lm
LUMENSMODES
7h
RUN TIME
270m
Low 120 lm 15h 100m
BEAM
DISTANCE
-- --
/