INS ELA 38873

ELECTRALITE INS ELA 38873 User manual

  • I have reviewed the user manual for the Emergency luminaire. This document provides instructions on installation, emergency testing, and battery replacement. I'm ready to answer your questions about how to safely use and maintain this device.
  • What should I do if I receive the item with broken or missing parts?
    Is it necessary to connect earth wire to the luminaire?
    How long before I can test the emergency mode?
    Can I dim this luminaire?
Helpline
If you receive this item with parts broken or missing, please telephone: 0333 0050077
Please have ready your name, address, tel. no., product reference, where purchased and parts required.
An answering service is in operation outside office hours and during busy periods.
We regret that we are unable to give advice on internal house wiring.
Cascade Holdings Ltd, Gorse Mill, Gorse Street, Chadderton,
Oldham. OL9 9RJ
This product should be disposed of responsibly at the end of
its life. Please recyclewhere facilities exist.
Check with your Local Authority or retailer for recycling advice
(Waste Electrical and Electronic Equipment Directive)
v2
IMPORTANT INSTALLATION INFORMATION
Installation should
be
carried
out
by
a
qualified
electrician in
accordance
with
the
latest
edition of the National wiring regulations.
These luminaires are for indoor use onl y
MaximumInputVoltage-220V-240VAC50Hz
Ensure that ALL electrical connections are tight without any loose strands.
Before commencing installation or maintenance, ensure electricity is switched off at the mains.
Class II, Double Insulated and earth is not required.
This luminaire is not dimmable.
Fitting only suitable to be used with round cable.
EMERGENCY TESTING
After connecting the mains supply check the following:
1.
The unit should be left on charge for a minimum of 24 hours uninterrupted supply before testing the emergency mode.
2.
There is one green indicator in the middle. After power is on the LED indicator will be on. The LED indicator is off when the
fixture is in emergency mode.
3.
To simulate normal mains supply failure, operate your key switch.
4.
The lamp will now light under emergency conditions.
5.
When
and Amp-hour rating.
the unit no longer meets its rated duration of operation the battery pack must be replaced with a battery of the same type, voltage
Emergency Installation and Inspection
Installation/Test
Record
Serial/Luminaire Number:
Installed
By:
Date:
Commissioned By:
Date:
Year1
Year2
*
Year3
Year4*
Monthly test
Signed
Date
Signed
Date
Signed
Date
Signed
Date
1
2
3
4
5
6
7
8
9
10
*The
battery must
be
replaced
11
12
/