2. Global Industrial
  3. 436CP55

Global Industrial 436CP55 User manual

  • Hello, I have analyzed the user manual for the Steel Bench 436CP55. This document provides detailed instructions for assembly and in-ground installation, safety information and a parts list, including specific hardware like M8 hex bolts and nylon lock nuts. I am here to assist you with any questions you may have regarding the product or its installation process.
  • How many people are needed for assembly and installation?
    What kind of safety equipment should be used?
    What type of surface is recommended for the bench installation?
    How often should the hardware be inspected and tightened?
1
User's manual Manual del usuario Manuel de l'utilisateur
Customer Service
US: 1-800-645-2986
Servicio de atención al Cliente
US: 1-800-645-2986
Service à la clientèle
Canada: 888-645-2986
Component Model #: 436CP55
In-Ground Mount
Steel Bench Without Backrest,
for 48" / 72" / 96"
Ref. Qty. Description
1 1 Bench
2 2 Leg
3 2 Leg Support
4 4 Steel Bar
H1 6 M8 x 25 mm Hex Bolt
H2 1 M8 x 35 mm Hex Bolt
H3 14 Washer
H4 7 M8 Nylon Lock Nut
Warning
• Assembly and installation of
equipment should be performed
by 2 people.
• Workers should use O.S.H.A.
approved safety and lifting
equipment.
Warning
• Ensure that the bench is
installed on a level surface.
• Ensure surface is of a strong
material, preferably concrete.
• Use proper mounting
hardware.
Warning
• Do not climb on, under or
through tables and benches.
• Two people are required to
move tables and benches.
• Do not use if any parts
are damaged.
• Inspect and tighten hardware
every six months.
• Replace rusted hardware and
damaged components.
Parts List
2
In-Ground Steel Bench
Without Backrest
H2
User Manual
REF. 2 REF. 1 H3 (x8)
H1 (x4)
H4 (x4)
REF. 3 REF. 2
1. Attach both Legs to the Bench, using the hardware provided. Use images below as reference.
2. Attach leg supports to both legs and bench top (3 points) with the hardware provided. Use images below as
reference.
3. Insert 2 steel bars (Ref 4) through each leg. Steel bars must be
symmetrically placed in order to function adequately during in-ground installation.
Steel bar must remain symmetric while in leg.
1. Dig a hole 24" deep and 9~10" in diameter.
2. Layer the bottom with 6" of gravel. Ensure gravel is well packed.
3. Mix concrete using proper sand/cement ratio.
4. Insert legs to base and apply concrete to its surroundings.
5. Ensure steel bars stay symmetric while concrete is poured.
6. Use level to ensure level installament.
7. Allow concrete to cure completely.
AB
B
A
1Assembly Instructions
2In-Ground Installation
REF. 4
/