Gainsborough AIR SPA and Light System User manual

Brand: Gainsborough

Model: AIR SPA and Light System

Type: User manual

Gainsborough AIR SPA and Light System is a user-friendly bath enhancement system that offers a relaxing spa experience and ambient lighting. With a simple control panel, you can activate the spa jets and adjust their intensity, or turn on the LED light for a soothing ambiance. The system features an auto-purge hygiene management system that automatically blows out residual water after use, ensuring cleanliness and preventing bacterial growth.

VERSION 1.0

AIR SPA

USER MANUAL

Brand Guidelines

Version 1.0 2018

T: +44 (0)1527 400 024

E: service@ghg-uk.com

www.abacushealthcare.co.uk

T: +44 (0)1527 400 022

E: service@ghg-uk.com

www.gainsboroughbaths.com

Brand Guidelines

Version 1.0 2018

T: +44 (0)1527 400 026

E: service@ghg-uk.com

www.accesswalkinbath.co.uk

Your new Air Spa and Light system

is easy to use, but we ask that

you take the time to read these

instructions carefully prior to use

to ensure you get the best out of it.

The buttons are perfectly safe

to use with wet hands.

SPA OPERATION

• Press the Spa symbol (bubble

image) to turn the system on

– see FIG. 1. The plus and

minus symbols will increase or

decrease the speed and power

of the blower.

• Press the Spa symbol a second

time while it is running and the

blower will go into variation

mode, where it will increase and

decrease in speed automatically.

• The third press will turn the

system off.

Once started, the systems will

run for 20 mins and turn off

automatically. To continue operating,

just press the button again.

CARE

• Clean the control panel, light and

jets as you would your bath, using

a soft cloth and mild non-abrasive

cleaning solution.

TECHNICAL REQUIREMENTS

• Your system requires a 13amp

IP65 Non-Switched fused spur

connection, positioning and

specication to be in accordance

with the latest IEE regulations.

Control Panel IP55 Rated.

• The LED on the button will

ash once every 8 seconds,

to conrm that there is power

to the system.

• They Air and Light system will

only work when the water level

is high enough (above the sensor

attached to the bath shell) when

the system is ready for use, the

LED will ash every 0.5 seconds.

AIR SPA USER GUIDE – 4 BUTTON FUNCTION

FIG. 1

LIGHT OPERATION

• You can use your light function

at any time during your spa

experience. Press the light

symbol to turn the light on

– see FIG. 1.

• The led lamp will slowly cycle

through a spectrum auto-rotating

colours. Press again and the light

will ash slowly and continuously

until stopped.

• The third press of the button

will turn the system off.

AUTO-PURGE HYGIENE

MANAGEMENT SYSTEM

• Once the system has nished

running and is emptied, after 20

minutes it will turn on the blower

automatically and blow out the

residual water. It will run for 3

minutes continuously and then

switch off.

• If the bath is used and lled

above the water level for more

than 30 secs, even if the air spa

is not operated, the blow out

function will be activated and

operate as above.

• If a function is active, when

the bath is empty (blow-out

function) the LED will ash twice

every second until the system

blow-out occurs.

Gainsborough AIR SPA and Light System User manual

Gainsborough AIR SPA and Light System User manual

Gainsborough AIR SPA and Light System User manual

Other documents