2. DAN DRYER
  3. 67020
67020

DAN DRYER 67020 Installation guide

  • Hello! I've reviewed the Installation Guide for the DAN DRYER HEPA filter 67020/67021. This document provides instructions on properly installing the filter for the LOKI hand dryer, including steps for locating mounting holes and securing the filter with screws. I'm ready to answer any questions you have about the installation process or the filter itself.
  • What is this document about?
    What is the first step of installation?
    How to finish the installation?
INSTALLATION GUIDE
HEPA lter, 67020/67021 for
DAN DRYER LOKI hand dryer
DAN DRYER A/S • Alsikevej 8 DK-8920 Randers NV • +45 86 41 57 11 • info@dandryer.com • dandryer.com
Introduction:
This guide shows how to properply install a DAN DRYER HEPA lter 67020/67021.
DAN DRYER A/S • Alsikevej 8 DK-8920 Randers NV • +45 86 41 57 11 • info@dandryer.com • dandryer.com
LOKI
1. Locate the mounting holes on the foot of the
dryer. Remove existing lter holder, if any, before
the new unit can be installed.
2. Place the lter unit on the holes over the air
inlet.
3. Fit and fully tighten the security screws on
both sides.
4. Installation/replacement of the lter is now
complete.
/