DieselSite 7.3L Timing Cover Repair Plate Installation guide

Home » DieselSite » DieselSite 7.3L Timing Cover Repair Plate Installation Guide

DieselSite 7.3L Timing Cover Repair Plate

Contents

1 INSALLATION by

DIESELSITE

2 Documents / Resources

2.1 References

3 Related Posts

DieselSite 7.3L Timing Cover Repair Plate Installation Guide

Manuals+ — User Manuals Simpliﬁed.

INSALLATION by DIESELSITE

1. Remove Balancer and LPOP.

2. Remove all old silicon, gasket material, and all debris from surface area of front timing cover and at least ½”

outside the area.

3. Use parts cleaner to remove all oil residue and put paper towels or something to keep any residual oil from

dripping out while you prepare the plate.

4. Make sure you check which side faces the timing cover and place a thin even layer of silicon on the plate.

5. Remove the towels and before any oil comes out, place the plate against the front cover aligning with the dowel

pins.

6. Install plate tool and use existing pump bolts to compress plate and silicon. Tighten to 15 Ft-Lbs.

7. After at least 12 hrs., remove bolts and plate tool. If you need to use a screwdriver to pry oﬀ, make sure you

only grab the tool and not grab the repair plate.

8. Use an exacta or razor blade to trim all excess silicon from inside grooves and around crank. DO NOT PULL

SILICON! ONLY CUT!

9. Install pump and harmonic balancer and start engine. Check for leaks

Documents / Resources

DieselSite 7.3L Timing Cover Repair Plate [pdf] Installation Guide

7.3L Timing Cover Repair Plate, 7.3L Cover Repair Plate, Timing Cover Repair Plate, Timing C

over, Cover Repair Plate, Repair Plate, Cover Plate, 7.3L Plate, Plate

References

Diesel Performance Parts | DieselSite, Inc.

Manuals+,