2. AMBIENTECH
  3. DT-xxV-xxW-W
DT-xxV-xxW-W

AMBIENTECH DT-xxV-xxW-W User manual

  • Hello! I've reviewed the installation instructions for the AMBIENTECH LED Driver DT-xxV-xxW-W. This document contains details on mounting procedures, wiring connections, and important safety precautions. It also provides specifications such as the 120VAC input voltage and 12/24VDC output, and its suitability for dry and damp environments. I'm ready to assist with any questions you might have about the installation process or the product itself.
  • What is the input voltage for the LED Driver?
    What is the output voltage of the LED Driver?
    What is the maximum distance between Wall Switch and LED Driver?
    What type of environment is the LED Driver suitable for?
1
4. Wire Connections
WARNING
To avoid fire, shock, or death, turn the power Off
at the circuit breaker and test to ensure
the power is Off before wiring.
ON
OFF
2. Punch knockouts for wiring
conduit access
1. Open wiring compartment
Wiring
compartment
Neutral
Ground
Line
--
+
LED Driver
- -
+
Black
White Yellow
Warm
White
Cool
White
Red
White
Green
Before You Begin
Determine the location of system parts:
1. Wall Switch
2. LED Driver
Note: Max distance between Wall Switch and LED Driver
30m/100 ft.
Mount the Driver:
Select a suitable location, which can provide
adequate support for the weight of the LED Driver.
Note: Install the LED Driver in a well-ventilated
area free from explosive gases and vapors.
3.
B. Position LED Driver at an angle
over the bracket’s latches
A. Mount the wall bracket
C. Place LED Driver on the
bracket latches
D. Align LED Driver on the bracket
E. Install the supplied lock screw
Mount the Driver:
Select a suitable location, which can provide
adequate support for the weight of the LED Driver.
Note: Install the LED Driver in a well-ventilated
area free from explosive gases and vapors.
3.
B. Position LED Driver at an angle
over the bracket’s latches
A. Mount the wall bracket
C. Place LED Driver on the
bracket latches
D. Align LED Driver on the bracket
E. Install the supplied lock screw
Customer Assistance
For more info
For technical questions regarding the installation or operation
of this product, please contact our customer support team:
www.ambientechinc.com
347-334-6368 ext 3
Quick Specs
Input Voltage 120VAC
Output Voltage 12 / 24VDC (Check Label)
Ambient Temp -30 °C - + 40 °C / -86°F - + 104°F
Environment Dry and Damp
LED Driver
E512089
R
Important Notes
Please Read Before Installation!
• The system is to be installed in accordance with the
National Electrical Code or local code.
• The system is to be installed and serviced by a qualified,
licensed electrician.
• LED Driver must be grounded in accordance
with the NEC or local codes.
With the power switched Off, connect the wires
according to the wiring diagram below.
DriveTone Installation P/N: DT-xxV-xxW-W
Installation Instructions
/