2. Technoflex
  3. Speed Bumps

Technoflex Speed Bumps Owner's manual

  • Hello! I've reviewed the user manual for the Speed bump. This document details the installation process using drilling and rebar spikes of the rubber speed bump, as well as basic maintenance recommendations. I'm ready to answer your questions about the product and its installation!
  • How deep should the drilled holes be?
    How long should the rebar spikes be?
    Does the rubber speed bump require maintenance?
We recycle for a better world
www.technoflex.ca
How to install a rubber speed bump?
I. Drill holes into the asphalt through the holes already in the rubber speed
bump. Make sure the holes are at least ½ inch wide and 3-4 inches deep.
II. Drive the ½ inch rebar spike through the holes in the rubber speed bump.
Rebar Spikes should be 14 inches long.
III. Rubber speed bump do not require maintenance; however it is advised to
periodically check the spikes to see if they came up. If they did, make sure
to keep them hammered down below the surface of the speed bump.
/