DQ14257AET/AEB / DQ14257 ET/EB / DQ14257 WT/WB / DB54257T/B / DPR14257T/B / DP54257T/B
57” PED TABLE W/15” BTRFLY
TBSR-11388BC-CNGN MADE IN MALAYSIA
PAGE 2 OF 3
STEP 2
NOTE : THE UNIT SHOULD BE ASSEMBLED BY 2 OR MORE PEOPLE.
ASSEMBLY
STEP 1
Hex Nut
Hex Nut
12 pcs
Lock Washer
Lock Washer (Large)
Large
12 pcs
Flat Washer
Flat Washer (Large)
Pedestal
Leg
Level Glide
Large
12 pcs
Lock Washer
Small
8 pcs
Flat Washer
Small
8 pcs
Wrench
Wrench
1 pc
Allen Key
1 pc
JCBC Bolt
8 pcs
HARDWARE PART :
Turn the pedestal upside down and attach legs to the
pedestal using the provided hardware as shown in Fig.1.
Once legs are attached to the pedestal turn the
Base Right side up.
Position the table top upside down on a solf, protective
surface such as carpet. Remove and discard the temporary
Wood Strip. Attach the side mounting plate using the provided
hardware as shown in Fig.2 , Then attach mounting plate
using the provided hardware as shown in Fig.2.
STEP 3
Unlock the hooks locks underneath the table and pull the table top wide
open equally from both ends. Align and attach the table top to the
pedestal by insert a the provided hardware as shown in FIg.3.
Lock Washer (Small)
Lock Washer
(Small)
Allen Key
Allen Key
JCBC Bolt
JCBC Bolt
Flat Washer (Small)
Flat Washer
(Small)
Mounting Plate
Side Panel
Lock Washer (Large)
Flat Washer (Large)
Wrench
Hex Nut
Unlock Hook
Remove Wood Strip
REMOVE
Must Remove
CARE INSTRUCTION
~ Be sure to use the same type of polish consistenly.
Your furniture will appear cloudy or streaky if oil
based or wax based polishes are interchanged.
~ Spray your furniture surface evenly. Wipe in a
circular motion with a soft clean cloth.