Workrite Ergonomics PET Mobile Pedestal Cover Installation guide

I have reviewed the Assembly & Installation Instructions for the PET Mobile Pedestal Cover (ACC-PAD-P-XX). This document outlines the steps for preparing the pedestal top, attaching the cover via Velcro, and dealing with misalignments. I'm ready to answer your questions about installing this cover.
What should I do before installing the Pedestal Cover?

How do I install the Pedestal Cover?

How long should I wait before removing the Pedestal Cover?

What should I do if the Pedestal Cover is misaligned?

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 1 of 1

#1500585 Rev A

A PET Ped Cover

Qty: 1

Assembly & Installation Instructions:

PET Mobile Pedestal Cover

ACC-PAD-P-XX

Parts Included

1 Clean the Mobile Pedestal Top

1.1 Clean the Mobile Pedestal Top with Windex or other non-soapy non-oily based

cleaner.

Note: Be sure to let the top to dry completely aer cleaning before attempting to adhere the Ped

Cover to the Pedestal Top

2 Place the pad onto the Pedestal Top

2.1 Peel the backer of the 4 Velcro pads in the corners of the Ped Cover

2.2 Carefully align the Ped Cover with the Pedestal Top and press the four corners of the pad.

Note: The PET Ped cover must be firmly pressed in place and le for 24 hours before attempting to

remove the Ped cover or the adhesive may fail

2.3 If the ped cover is misaligned do not immediately try to remove it. Wait 24 hours for the adhesive

to set properly and then li from one corner to release the Velcro and remove the ped cover. Then

realign the Pedestal Cover to the Pedestal Top and press firmly to reattach the Velcro.

2.1

2.2