Page is loading ...
Installation Manual
Rail Mount with Versa Grill Adapter
This mounting kit can be used with your Jackson Grill. It fits the following products:
• Versa 75
• Versa 100
While this grill mount is a very strong and durable mount, it is not recommended to leave the grill attached to
the mount if the rail system you are mounting to is moving.
Package Contents:
The following parts are included in this package:
• 1 x Rail Mount
• 1 x Adapter Plate includes 4 stainless steel screws & washers
• 4 x Nyloc Nuts and Bolts
• 1 x Installation Manual
Installation Procedure:
1. Attaching the H Bracket
a. With the four Nyloc nuts and bolts provided, attach the H Bracket to the supplied adapter plate
(see Figure 1 for reference).
2. Attaching the Adapter Plate
a. With the S/S screws & washers provided, fasten the adapter plate (with the H bracket) to the
grill by lining up the installation holes on the plate (four out of the six) with the four existing
threaded holes in the grill’s base (see Figure 2 for reference).
Figure 1: H Bracket mounted to Adapter Plate Figure 2: Adapter Plate mounted to underside of Grill
3. Positioning the Mount
a. This mount can be used with horizontal rail, vertical rail or on some angled rail. It can be used
with square rail or round rail up to about 1-1/8 inch diameter.
b. Attach the clamps to the rail as shown in Figure 3. Tighten bolts evenly on all corners to ensure
a tight fit. Attach the mount so the “tongue” of the L bracket is pointing outboard from the rail so
the mount is not in the way when there is no grill attached and that the grill is held over the side
when it is mounted.
Figure 3: Rail Mount (Horizontal and Vertical Mount)
Tips for Using the Mount:
Before mounting the grill, release the stainless steel clasp so it is hanging loose. Most of the mount has been
assembled for you. When the H bracket is on the grill and the mount bracket is on the rail, hold the grill
securely and slide the grill on to the mount. The “tongue” of the L shaped bracket will slide into the space
between the H bracket and the grill base tray. Once the grill is firmly slid on to the tongue of the mount, tighten
the latch/clasp so that the leading hook of the clasp grips the H bracket on the grill. This clasp will be stiff when
new but you will be able to attach and remove your grill as often as you want with your new mount kit. The
clasp will become easier to open and close with use but will always firmly hold your grill in place.
**Caution: Do not place grill on latch bracket until all mounting nuts are tight.
Tongue
/
