ESAB Analogue remote retrofit kit Assembly Instruction

ESAB
Brand
ESAB
Model
Analogue remote retrofit kit
Type
Assembly Instruction
8
1
Analogue remote retrofit kit
Renegade
™
0445 840 880
Assembly instruction
0463 608 001 GB 20180413
For contact information visit esab.com
http://manuals.esab.com
2
7
1
2
7
Software update after installation of the analogue remote kit
1. Copy the correct secondary boot upgrade file (version 2.3 or later)
to a USB flash drive.
2. Rename the file sparc.fcf.
3. Disconnect any digital remote control or foot pedal from the
welding power source that is going to be upgraded.
4. Insert the USB flash drive into the power source USB connector.
5. Wait until the boot upgrade process is completed.
6. Power off the welding power source and wait for at least 1 minute.
7. Copy the correct system software upgrade file
(version 1.13.x or later) to an empty USB flash drive.
8. Insert the USB flash drive into the power source USB connector.
9. Wait until the system software upgrade is completed.
Verify the installation of the remote functionality by connecting
an analogue remote to the power source and control that the
remote and power source display are synchronized.
For additional guidelines, such as location of software files,
see “SOFTWARE UPDATE AND CONFIGURATION”
in the service manual.
6
3
3
6
CN6
CN11
CN7
CN2
CN1
3 Nm /
26.6 in. lb
CN 29
4
5
4
5
CN 11
CN 6
CN 29
CN 1
CN 7
CN 2
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

ESAB Analogue remote retrofit kit Assembly Instruction

ESAB
Brand
ESAB
Model
Analogue remote retrofit kit
Type
Assembly Instruction
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents